I have used this product with success on the mold problems!
https://www.homedepot.com/p/Greased-Lightning-32-oz-Super-Strength-Multi-Purpose-Cleaner-and-Degreaser-17569248593/300802077
I had this issue last year on my Port engine reservoir. I believe threads on the filler neck get worn down(or stripped) a bit coupled with vibration lets fluid out the top. I was finding small puddles in the bilge. The cap would only tighten so far then loosen. Since your leak is coming out the...
These switches corrode frequently then do not operate. I removed and cleaned them on my 2001 then coated with dielectric grease. Not easy to get to the aft one but doable! Lots of info on the net and you tube videos.
Well, after 3 weeks my Norcold started to work again on AC power so I'm in the same boat as Dave, the original author of this thread. I'm not sure what sort of electronic Gremlin exists that would allow the AC part of it to work intermittently? All I did was pull it out of the cabinet part way...
Dave, Hope one of these links help. Still not sure what I'm going to do including getting a new fridge. Cheers!
https://rvfridgeguys.com/norcold-power-supply-160113911-fits-the-de441-de451-de490/
https://lyratronix.com/product/norcold-160113911-repair-service/
Following this thread as I have a 2001 340 that has this exact problem that just showed up!
The only difference is the fridge green light is steady on shore power with no compressor power.
Wondering if it would be just as cost effective to replace the whole unit? Not sure how much more to...
Great advice so far! I made the switch as you are doing two years ago. I had a SR bow rider 210 and now have a 2001 DA 340 with Bravo III. I keep the boat moored in fresh water and will be using it is salty Puget Sound about 2 weeks out of the year. It seems to have spent it's life this exact...
I upgraded(my previous upgrade) on my 2001 340 DA that has sterndrive. It's an electronic control module (Glendinning Smart Actuator II). This took a smaller profile than the original space but you could do a similar platform to fit. It is a hard plastic material and is glued down over the...
I'm also a new owner of an 01' 340 and have same issue. I dont have 1/2 and Dont flush(full) lights and have taken the cover off and cleaned the floats. Still no indication. I do have the power and empty lights however. Wonder now if those 2 lights above it are burned out on the panel but no way...
WANTED: My boat didn't have the "C" clamps that secure the original AC and tray to the wood planks in the forward berth compartment . Anyone have a source for these? TIA
I might have two starting issues going on here. Sometimes on startup and idle on the starboard engine it will show no oil pressure on the gauge and red light will be on steady on the systems monitor. Other attempts it will start and idle fine with good pressure on gauge and red light out...
Just cleaned all of my non skid with a mix of boat soap, bleach and water and a cheap(low psi) electric pressure washer. Easy removal and now it sparkles!
From what I gather on forums, this gauge goes out every 1 to 2 years and most don't repair the sender anymore! Both of mine are inop and dont use them.
I went ahead and replaced the tach with a new one. The hours meter comes up on the new tach(0.0) but the needle on the gauge is parked at zero with engine at idle. I'm 99% sure I hooked it up right but with 15 wire inputs that go into the gauge it might take a while to diagnose! Anyone have a...