Took off the switch panel (12 screws) and saw there were two outgoing wires.Nothing happened when I switched it on. Was able to trace one of the to a disconnected wire and will use that
Can anyone tell me where the wire from the accessory switch on the dash goes? It does not seem to do anything, and I would like to use it to power some electronics
I am looking to add my Fusion 270 radio to my NMEA2000 network so I can control/see it on my Garmin MFD's. Anyone know of a good path from the helm to the cabinet above the sofa on the left where the radio is installed? I did this on my 340, but that was much easier as the radio was in the...
I started reading a month ago. I actually ordered an RS11 first, but wanted the better accuracy of the EMU-1. I installed it last weekend and once I took Skybolt's direction on the NGX settings, it fired right up. I will update here as I go, and will be happy to share the teleflex profile with...
For anyone else looking at this part, I spoke with Garmin support. Go to the engines page/settings or options/installation - RPM Rounding. I am looking forward to getting back to the boat tomorrow to verify this.
As to the sender and custom gauge manager, is there anywhere that shows current...
Thank you @Skybolt, that was indeed the problem. Once I set that correctly, it showed up.
Now I have two issues to address. The boat has Teleflex gauges on her (CAT 3116's) and none of the existing profiles match well with these Teleflex units.(oil pressure and coolant temp) I am trying to...
Cannot figure out what I am doing wrong. Today I wired six gauges and two tach’s to my new EMU-1, added the EMU-1 and a NGX-1 to my NMEA2000 network. I installed drivers on my win 10 laptop and then Actisense Toolkit. Upon starting the engines (cat 3116s) my Garmin 1242xsv let me know it found a...
For anyone else working on this...1. Junior Bar Drain (Glacier Bay brand) to a 2. 1 1/2" pvc stand pipe to a 3. 1 1/2" 90 degree elbow to a 4. 1 1/2” to 3/4” step down adapter to a 5. 3/4” mpt to 1” barb. The barb is slightly small but the hose clamp makes up for it. No leaks, all happy
Doing some work on my aft head. Can anyone tell me the size of the hose running from the sump to the drain? I am completely missing the drain assembly, and on another thread someone said the “junior bar sink” drain at Home Depot will work. I just want to be sure I get the right size adapter to...
Uggity Mug...not my first boat so I understand marine prices and all...but it is my first dance with a caterpillar...almost $300 for 4 hoses and some clamps...I guess each leg of the caterpillar must be paid. :)
Found these two from another thread.
9Y-6218 for the top one to the heat exchanger, looks correct in the picture
9Y-1330 for the bottom short one to the cooler. The picture shows it as an angled one. Is it a wrong part or a wrong picture as mine is a straignht piece.
Anyone know if this is...
Disregard that...found this really excellent thread on the install.
https://www.clubsearay.com/index.php?threads/cat-3116-%E2%80%93-raw-water-pump-change-replacement-help.113146/
I need to change the raw water pump in my 1999 400 DA with 3116s. Is anyone familiar with the JPR-S7632? I found that for less than $600, whereas the Sherwood P1710C was anywhere from $825 to $1,000. Just curious if the JPR is a quality product?