Search results

  1. L

    220 DA thread

    I use the cheapest ATF I can find. Power steering fluid too. Never heard of or tried using motor oil. Been using ATF since 09. Works like a charm. I'm no expert so take my advise at your own risk. Happy boating.
  2. L

    220 DA thread

    Well, I wimped out in regards to starting the engine. Just couldn't take that risk. Instead, I started to take the tank out. I disconnected all 3 hoses. Removed the brackets holding the tank down in the aft cabin area. Tried lifting the tank but there isn't enough room too lift. Tank hits the...
  3. L

    220 DA thread

    Wonder if I should try running engine again and check for leaks at the fuel/water separator, and pickup lines first? Kinda scary just thinking about starting engine with a fuel leak.
  4. L

    220 DA thread

    So I removed the aft cabin center floor. Floor was held down with stainless screws all around. There is a bracket at the aft section of floor that you can't see until you pull the floor out but there are 2 screws at the very back of floor very close to back wall almost tucked under the rear...
  5. L

    220 DA thread

    H2ONUT, I really doubt that the fuel tank can come out thru the cabin. Even if I could get it up into the aft cabin, I wouldn't be able to take it out of the aft cabin into the main cabin and out the door. Looks like the tank is too big to fit through those areas. Or am I wrong? Guess I'll...
  6. L

    220 DA thread

    Houston I have a problem!!! Looks like I have a fuel tank leak. At least thats what I think it is. Under the engine hatch forward of the engine is the fuel tank. The tank is exposed from the top (and always has been since I bought it) In between the aft wall of tank and bulkhead that...
  7. L

    Upgrading Bilge Pump

    I'm upgrading my 2 bilge pumps located in the engine bay. They are 800GPH Rule. Each with a float switch. One has a switch at the helm. I'm upgrading to 2 2000GPH Rule Pumps. I upgraded the discharge Thru-hulls. That was the easy part. I'm having trouble figure out what is normally done to...
  8. L

    220 DA thread

    Anyone know what size/length control cables are used in our boats? And... What length are the trim pump to transom (inside) hydraulic hoses we have? Thanks!!
  9. L

    220 DA thread

    The throttle control at the helm is really dated and has seen better days. I'd like to upgrade to the new 4000 series from mercruiser pictured below. Is this a simple swap out?
  10. L

    220 DA thread

    Theres no way that I'm getting GALLONS of water in the bilge from the bilge vents. I might get a sprinkle here and there or if it rains really hard with some horizontal rain.
  11. L

    300 DB interior restoration

    Great interior restoration!! I'm really impressed. I too am a DIYer. How do you butt up the ends of the headliner? There is a seam that runs from port to starboard in the headliner. Was that sewed together or just glued end to end or was it glued overlapped? thanks for posting this...
  12. L

    29 Amberjack engine access hatch

    Nice project!! Does that affect the integrity of the floor? I would recommend sealing the exposed wood after cutting too. How about a 6 month update? Thanks
  13. L

    220 DA thread

    I constantly drain what seems like gallone of water from the transom drain Agee each retrieval. I fish offshore with my 220 which includes trolling. The rub rails have been sealed. I found water on the shelf where the battened sit toward the Back oppsite of water tank while in the drink. I'm...
  14. L

    Cabin Hatch

    I used a polyurethane roofing adhesive in black. Has mold resistive properties, and bonds to many materials. 5 bucks at home depot. I cleaned up the old stuff. taped off the top and bottom of plexiglass, and the inside and outside of frame to keep it nice and neat. Using the caulking gun...
  15. L

    Cabin Hatch

    My cabin hatch needs some attention. the plexiglass has separated from the frame. It has like a rubber gasket or soft rubber of sort on it like if it came from caulking. Or it may just be old and melted or whatever. Point is, I need to reseal the plexiglass to the hatch frame. Can I just...
  16. L

    Pole Anchor light

    Gofirstclass, Thats a good Idea for sure. Unfortunately, the base needs a replacement too. The light itself (shell and insides) is also toast. So I placed an order for a 6 foot stern light pole and base and should be here in a week or so. WM had up to 5 ft only. thanks all.
  17. L

    Pole Anchor light

    Thanks for the quick response! Yes, I tried that one but it did not work with the factory base. Last time I checked, the bases supplied by West Marine too big to fit within the space installed. Looks like I'll have to replace the base....So far I've found a SeaSense mount and pole. Have...
  18. L

    Pole Anchor light

    Where can I find a replacement 69" anchor pole light that will fit the factory mount position in my '89 220 DA. The long pole anchor lights are difficult to find. Sucks not having that light cause I can't stay out past sunset. Thanks for any help.
  19. L

    Amberjack Thread -

    Oh come on, one picture...thats a tease. I'm on the fence between the 290 Amberjack and the Wellcraft 290 Coastal. When the time comes to buy, I'll have to Sea Trial both and see. More pics......pics of the engine bay would be nice too. Congrats on the new purchase. have fun with her.
  20. L

    220 DA thread

    thanks for the pics
Back
Top