Search results

  1. flying_steve

    Official 290 Sundancer Thread

    Doing a solar install on a 99 290 Sundancer. Looking for advice on running the cables from the arch to the batteries via the battery switch compartment. Not sure how to run them once I get down to where the arch meets the sidewalk. Thanks!
  2. flying_steve

    Official 290 Sundancer Thread

    2 questions - does anyone know the approximate square footage of the ‘99 cockpit area? Considering an SeaDeck install and attempting to get an estimate on cost. Second question - anyone towing a dinghy? Any tips? Thanks
  3. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Does anyone know the approximate square footage of the cockpit area? I'm trying to get a rough idea of how much a decking install is going to be. Thanks.
  4. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Anyone know what LED lights I need to replace my nav and anchor lights with? Thanks
  5. flying_steve

    Official 290 Sundancer Thread

    1999 290 Sundancer question: Is the voltmeter on the panel showing total system voltage or just for the port starting battery? Woke up to find 8 volts this morning after added a LOT of water to a very dry battery (the solo port side battery). Thanks,
  6. flying_steve

    Dead battery?

    Checked the fluid levels in my batteries yesterday. The 2 newer ones on the house side were nice and full. The one independent battery which is my port side starting battery (Interstate RV/Marine deep cycle) appears to be older. Popped the covers and could see the plates were exposed. The...
  7. flying_steve

    Official 290 Sundancer Thread

    Has anyone replaced the florescent lights in the galley with LEDs? Any tips or tricks to bypassing the ballast? Thanks
  8. flying_steve

    NW Pine Island (Ggn Bay)

    anyone know anything about Northwest Pine Island on Georgian Bay? Doing some exploring on the charts and google maps and I see on the satellite pic it looks like a neat spot with a cruiser dock on it. Don’t know who it belongs too though. Co-ordinates: N45.0158547,W080.0571092
  9. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Hi all, My engine controls are super stiff. Mechanic is recommending new shifter and throttle cables as well as replacing the controls themselves. Anyone done anything like this before? Changing the controls seems to be overkill to me.
  10. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Anyone able to point me in the direction of an LED replacement for the fluorescent lights in the galley area?
  11. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Did you put anything under the mount or just put it right on to the platform? Thanks!
  12. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Great, thanks. I've got plas-teak on the deck too so I'll go 2" then. No problems drilling the platform at all? This is my first project for the boat we bought last year so I'm apprehensive!
  13. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Looks great. I am about to mount the same grill pedestal mount I see you have attached. How long were the bolts you used? I'm not sure how thick the platform is and the boat is still under shrink wrap at the marina an hour north. Thanks.
  14. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Anyone know the transom locker width? I’m shopping for a grill and want to make sure it fits. Thx
  15. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Did you do the install? I’m guessing through bolts and some 4200 are enough? I have synthetic wood decking on my swim platform and I’m nervous to drill it.
  16. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Anyone have any examples or tips for mounting a grill/BBQ? I’m trying to decide on a rail mount above the aft storage locker or installing one on my swim platform towards the starboard aft corner. Thanks.
  17. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    My mechanic recommended “whale tails” for my boat. Says I’ll notice a huge difference with them. 2 x 4.3L engines and alpha drives. Anyone have any experience with them?
  18. flying_steve

    WANTED - hand mic for Raytheon 210 VHF

    It is...having a hard time finding a new plug though...
  19. flying_steve

    WANTED - hand mic for Raytheon 210 VHF

    Looking for a replacement mic for my old Raytheon 210 VHF. One of the wires is broken and it's a tough fix. Of course it's the PTT button wire.
  20. flying_steve

    Official 1998 Sea Ray Sundancer 290 Thread

    Any solutions for a bow sun pad?
Back
Top