Search results

  1. K

    7.4 MPI - bad sound

    Hello! Im got a new problem with one of my engines, when it's warm this sound accours. (Se the video) The sound is sometimes louder and sometimes almost gone. Last year i changed the belt, belt roller, waterpump, manifolds and risers om both of my engines so i dont think it's belt related...
  2. K

    New manifolds and risers, air pocket?

    Hello, I have mounted new manifolds, risers, full flow gaskets as it was before, new exhaust hoses, new waterpump with impeller and so on.. on both my engines. I have a half closed coolingsystem At start up my port engine got seawater flow in about 4 seconds. My starboard engine diden't get...
  3. K

    Changing manifolds, problem?

    Hello, Im changing my manifolds and if i look/feel at the contact surface around the exhaust port of the block you feel that the surface is a little uneven/ruff. Not as smooth as the manifold, is this going to cause any problem with the gasket not keeping it tight? I haven't had problem...
  4. K

    Fluids for trim tabs 340 DA - 2000

    Hello! Does anybody know what type of fluid i have in my boat? Edit.. saw now that we had a tab forum and now i can't remove this thread. Thanks / Kim
  5. K

    340 DA 2000 - Cutlass and shaft

    Hello! I bought my 2000 340 DA two years ago, the old owner have changed both props to 5-blade (for slow speed fuel economy) and also the shafts/cutlass and the shaft seals in the boat. Late this summer i went for a swim and started to clean the hull/propps/rudder and such from thin layer of...
  6. K

    340 DA 2000 - front deck

    Hello! Does anybody know how far the plywood stretches backwards? Below the front hatch it looks like it stops about where ive made the marks. Well it's time for the deck repair! Yay.. Thanks / Kim
Back
Top