Search results

I had a similar issue with my aft EIM. It started erratic and then nothing, no blower, windless, nav lights, etc. I went through the recommended checks of connections and ground but no go. I ended up replacing the module and solved the problem. I was also told (and read on this forum) that...

A repair or refurb service would be nice. The issue is that the new EIM and old switch pads don't work together. You have to replace both. I have isolated my issue to the aft EIM however since the blower is on the left switch pad and windless, nav lights, etc. are on the right, means you have...

Voltage checks out good; 13.15 volts. Ground connections on both ends are tight and corrosion free. This is a fresh water boat and no signs of corrosion anywhere. I'll try running a new ground to the battery tomorrow. Thanks for the suggestions.

I've lost all functions that run through the aft EIM; blower, windless, cockpit lights, anchor light, bilge light. Everything started flaking out and then went out all at the same time. All wiring appears to be tight to the EIM and all breakers are on. Is there anything else to check or is...

First off, hello! I'm amazed at the knowledge represented on this forum. I've learned so much about our 280DA from reading all 421 pages of this thread. I'm not new to boats; I've had boats all my life but mostly outboard center console fishing type boats. This is our first cruiser and we're...