Search results

  1. C

    1978 Sea Ray 260 gas tank removal

    Nice to read these messages, and see that picture. I had to replace my gas tank when I bought my boat, a 1980 26 Weekender model. Similar centerline fuel tank and a 260 V8. But it was easier on the Weekender. Just a screwed on cover in the center of the cockpit. And there was no foam to get...
  2. C

    is there any other 410 415 or 440 ac owners out there

    Too bad there are so many comments by people with boats other than those 3 in the title. It makes reading the thread very difficult and irrelevant.
  3. C

    How is Mercruiser Alpha I Gen I Sterndrive control supposed to work?

    Thanks guys. I was afraid of that. It always worked like that, then I wondered if that was how it is supposed to work. I think I got a small oil leak inside one cylinder, which now won't compress all the way. Maybe some oil where it shouldn't be. Maybe forced past an internal seal.
  4. C

    How is Mercruiser Alpha I Gen I Sterndrive control supposed to work?

    If I have my Alpha I sterndrive all the way down, and I hold the UP button, it raises the outdrive until it hits the designed height for that setting, then it stops rising automatically and the pump shuts off. (Assuming my trim sensor is set to specs). Good. If I then hold the DOWN button the...
  5. C

    1981 Sundancer no raw water strainer?

    Yeah, I'm still running an outdrive with a lifting hook on the top. As I said, its a 1980. It too is a pre-Alpha. My engine is the 5.7, where you have the 7.4. Today that would have a Bravo drive on it. The Alpha was never designed for 7.4 L engines. I recall they had some heavier outdrives...
  6. C

    Model 410,415,440 Aft Cabin Fuel Tanks

    Anyone familiar with the 41 Aft Cabin of the late 80s? Models above are similar. I'm looking a these boats but I'm concerned about the fuel tanks. I believe they have 2 x 200 gal aluminum tanks. If I have to replace them I wonder what is involved. Does anyone have any idea? Thanks Cap10pat
  7. C

    1981 Sundancer no raw water strainer?

    I have a 1980 26 Weekender - almost the same. The water pickup is a thru-hull just in front of my engine on the port side. The hull was manufactured with a similar hole drilled on the opposite side, but, having a single engine it was never used. I don't have any additional seawater filter -...
Back
Top