Thank you BT, Yup, Florida salt water. I will add this to the list to eliminate. Risers and manifolds were replaced recently but could have a leak. Would a fouled plug be obvious? Engine seems to run fine.
Thank you Henry for your advice. At this point I think the ghost theory fits my situation. Marine Max has hooked up their scanner numerous times and I do not get a clear answer to what is going on. Just a firm bill. Marine Max will once again be out May 1st. I will be insistent that they start...
I have a 2012 Sea Ray Sundeck 260 with a ECT 350 Mag MPI DTS BR3 Engine. I keep getting an Engine Misfire Alarm on the Smart Craft 1000 Tach which gives off a single beep. Engine runs fine but alarm beep keeps going off. Marine Max has been out 4 times for this problem. They have not given me a...
Just letting you know you were right. Marine Max looked at my problem along with numerous other issues ($15,000 worth)and it was the transducer. Thank you for replying to my post.
NO, tried shutting everything down including batteries to reset code. Alarm and code still active and boat runs fine. Alarm is going off for a reason, scared to run it very long.
Thank you very much, first boat and learning. Found the senor at the back o the motor. Cleaned connector and have not had an alarm so far. Also ordered new sensor since they go bad frequently. Looks like Salt away is a super product especially with me running my boat in salt water down in St...
Tach. gauge on my boat is showing and beeping that I have an engine misfire. At this point boat continues to run fine. Any ideas where to start looking.
Where will I see the water pumping over the side on a 2011 Sea Ray 260 Sundeck? Tach. shows all temps reading fine ruling out impeller. Just alarm goes off at idle sometimes stating critical water pressure. Any idea where sensor is located on 350 Mag.?
2011 Sea Ray 260 Sun Deck. Can someone tell me what is happening. Boat runs fine until you stop and go to idle, alarm comes on saying critical water pressure. Water temp is at 160 and oil temp is at 150. Any ideas?