Search results

SOLVED! DEAD IN THE WATER-Stalled after forward shift- now won't crank at all! Got her running! It was the slave solenoid. New one was $20. Started immediately after I replaced it. Replaced air filter cover and hissing has stopped after turning off motor. I asked a tech about the stall during...

Mechanic said I don't have an interrupt, as I have a Bravo. I'm just trying to figure out the hissing now, and why it won't start. At least I can replace the slave solenoid and it will crank!

NEW DEVELOPMENT! Bypassed slave solenoid and motor started cranking, but didn't turn over. After stopping cranking, motor is hissing for about 10 seconds. No steam, smoke, etc. just hissing. Any ideas?

Thanks very much for all the feedback! Here is what I learned today in 2 hours: -Could not locate a neutral safety switch. Was not where it should have been according to online research and images (looking near black casting on left side of picture by shift cables). Thinking it is not present...

Thanks for the reply! Only alarm when I turn key now. No cranking. Started fine 5 minutes before stalling. Oil was checked a week ago and looked fine. Haven't removed any plugs. Doing research I have discovered it could be a sticky\stuck shift interrupt switch. I wonder if that is what is...

Just charged batteries; had all power working. Started motor, (after a few key turns with no cranking). Warmed up a few minutes, backed out into harbor, shifted into forward and lurched a few feet forward,then motor died abruptly. After that, no more cranking, dead in the water. Tried waiting...