Search results

So i checked connections and both power and fuel pump relays mounted next to the ECM. both are good. I'm going to swap crank case sensors between motors tonight and try and find fuses located on block. I don't have my engine serial numbers as they are wore off on the engine cover. Boat didn't...

Where is the crankshaft sensor located? I seem to remember reading something about it being under the distributor cap? Is there a way to test this sensor? Would this make my gages go dead as well? I'm going to swap the fuel relay and ignition relay today to see if anything changes. They are the...

Thanks for the response Todd. One thing i forgot was the starboard engine also had some sweating on the left hand riser like it was getting wet. all 3 others were completely dry. Not sure if this is another issue or just residual moisture being burnt off from me cleaning the bilge out. (simple...

2006 290 Sundancer with twin 5.0 mpi's. I changed out both seawater pump impellers and then took the boat for a cruise. ran it up to about 3500 rpm and cruised around for a bit. Everything worked great. Came back into the harbor and Boom, lost my starboard engine and gauges abruptly. No...

2006 290 Sundancer with twin 5.0 mpi's. I changed out both seawater pump impellers and then took the boat for a cruise. ran it up to about 3500 rpm and cruised around for a bit. Everything worked great. Came back into the harbor and Boom, lost my starboard engine and gauges abruptly. No...