Search results

We replaced the fan (requires an 18 inch #2 Phillips), and it worked. Looks like 11 to 14 degrees in the freezer and 39 to 42 in the fridge once we tucked it back into the box. Thermostat is about 85% of max. Looking at additional venting, perhaps drilling out at 3 or 4 inch vent hole in top...

It turns out the compressor fan does not work, so they are sending another one. It takes an 18 inch Phillips screwdriver to get the old one out. Should be fun? Sent from my iPad using Tapatalk

After 5 days at 3/4 max I have 36 in the freezer and 55 in the fridge. Today I propped opened the cooking elements next to the fridge box to allow more ventilation. Will check tomorrow. If that doesn't work, I'll pull the fridge out into the cabin and put it on max like you indicated. The dealer...

Thanks to this forum thread I was able to replace my old Norcold with a vitrifrigo 2600i series fridge. Pretty much worked exactly as Air O'Nautical indicated. The only issue I have had was getting the fridge to cool down. Had to adjust the doors to seal but 48 hours later it's 60 degrees in...

New to the thread, this is very encouraging to me. I want to replace my Norcold with a Vitrifrigo but could not figure out how to remove the sliding door to the cabin. It would give my 21 1/2 inches to get the old one out. You indicate that a stripped down Vitrifrigo could fit through that...

I need to remove my Norcold refrigerator that cannot be repaired and need to remove the sliding door to the cabin to get enough room. Does anybody know how to remove the top panel and door on this model? This is on a 1996 Sea Ray EC 400. Sent from my iPad using Tapatalk