If it were your boat would you run that pump housing? At minimum I will put a new impeller in it even though that one is good. It is just a pain to get to.
Sent from my SAMSUNG-SM-G891A using Tapatalk
The heat exchangers actually very clean from what I thought it would be I found a small piece of seashell and that was it I plan on maybe trying to blow it out it was wet last night when I looked at it. And just make sure there's no instructions but yes the gaskets and thermostat are on the way...
Here is some of what I have found so far. Opinions welcome, think I will be getting a hardin marine stainless pump.
Sent from my SAMSUNG-SM-G891A using Tapatalk
Ok I'm gonna open it up tonight and take a look around. I went ahead and ordered new thermostat, and end seals for the exchanger. And will be draining anti freeze, and pulling the raw water pump to have a look see.
Sent from my SAMSUNG-SM-G891A using Tapatalk
Fresh water . I haven't had a chance to check exchanger this season . Opened before winter last year and seemed pretty clean. And have been out maybe 10 days this year.
Sent from my SAMSUNG-SM-G891A using Tapatalk
I have an 05 496 mag. With bravo 3 390hrs All stock except captains call exhaust. What I noticed yesterday is while running wot or close to it 4000 RPMs + , my temp teachers high as 186°f . Of course I slow down and came to an idolle the temp went back down to 170 168. While running about...
Think this is the 3rd I have bought. I may I need to look for a new dash piece and just put some nice stainless push buttons or something.
Sent from my SAMSUNG-SM-G891A using Tapatalk
Anyone know of a spot to get these switches I have ordered a few now and by the time I pay and get them shipped it's near 20$ a piece. I'm guessing they less than $0.50 to make. Picture is what I have in an 05 sundeck . Thanks. Guess I may just upgrade them all if they keep breaking.
Sent...
Heading down to lake next Thursday. Wife and I want to buy a swim mat. I was just planning on going by iguana and see what they have, but I open to opinions. Limitations are I want to be under 600 , and I have a 270 sundeck so the factory swim platform isn't huge, there for I'm thinking 12...
I drive on. I'm sure it would of happened either way considering the one gouge happened when unloading. The yellow roller is soft. I can flex it by hand. Think they could build a stop bunk for it, being how the sundeck has a rounded bow right there?
Sent from my SAMSUNG-SM-G891A using Tapatalk
After cooling down about the unfortunate event , I am ready to ask for some advise. I bought my sundeck last year and at the same time purchased a new trailer to go with it. It seems that the roller in the front of the trailer is very soft and the boat smashes it ( it was this way when I...