Search results

Hey Gang! Completed the helm electronics update. Thanks to T Daleo, Capt Rusty, Frank W, and many more, I was able to get it done myself and professional ! I pulled out all old electronics, all old wire and coax, still have to remove old Loran and GPS antennas. Installed new E165 Raymarine...

Hey Gang!! Question for the knowledge base out here: Last year I had a mechanic replace my Type 1 AutoPilot hydraulic pump support bracket. (It was loose and somewhat rotted). This required the removal and replacement of the Type 1 pump, and I'm (now) sure they did not bleed the system...

Haven't seen any pics of this fixture yet. Anyone know how to access the bulb? The plastic lens at the bottom is glued in.

Hey Club SeaRay !! Anyone have or know of where to acquire a Sturdy brand AccuSync engine Synchronizer? Sturdy no longer supports, or does electronic repairs on these.... (they can do mechanical repairs), so I'm looking for a replacement unit, new or used.... Thanks! Here's the unit...

Hey Club SeaRay!! Here's another one from the new guy.... On my 370AC with twin 454's, as I come up on plane the port engine will occasionally rev to higher rpms than starboard....(feels like what I've read to be inboard cavitation?) I can quickly pull it back for a moment, about back to...

Hey Club SeaRay! Here's another one from the new guy: Today while cruising Lake Michigan, my Systems Monitor display panel lighted up the "bilge high water" red light. It came on after a total of over an hour and half of cruising, 20 min on plane cruise, and then a solid hour of slow cruise...

Hey Club Sea Ray, New member here, getting the new vessel ready for the water here in Michigan. Wife is replacing all the fabric and design elements, but we can't figure out how to remove the valance panels in the v-berth (see photo). any ideas? Thank you ! LB