Search results

  1. C

    1986 390 water flow

    I may just wait till spring, in was hoping to get resolved before hand so I'm ready to go in the spring. But waiting might be a better idea. I have plenty other things to focus on. The boat has been in the Chesapeake the passed 12 years not sure before that.
  2. C

    1986 390 water flow

    It is an odd scenario, because both motors began running warm at the same time. The motors are fwc. The manifolds have coolant running through them not raw water. The boat is on the Chesapeake. The mufflers make sense as to why the intermittent water flow, I was hoping that this was the issue of...
  3. C

    1986 390 water flow

    The water flow isnt a new issue I've owned the boat for 2 years. But I do run at 193 degrees at cruise. Once I come down it takes several seconds to begin to cool. As far as the flow it's one of those things that I see a boat doing something different than mine I try to get it fixed. I am...
  4. C

    1986 390 water flow

    Happy holidays everyone, this past season I've been battling some warmer engine temps, also i am wondering about how much water flow i should have coming out of the exhaust, when I start the motors it takes 10 or more seconds until I get water out of the exhaust. Once pumping it is not a steady...
  5. C

    Official 390 E.C. Thread

    Have a major problem. I am down on the boat and was cleaning the engine room, i noticed my port raw water intake is leaking at the base of it. Does anyone know what parts are used for these? I looked at intake thru hulls however mine has a flange on the inside of the boat that the nut runs tight...
  6. C

    Onan 6.5 mcck

    I am having an issue getting water discharge from the generator. I replaced the impeller this weekend the old one had 1 fin left. So i thought that was definitely the issue. Started the genny still no water. From here what are some other common or non common issues?
  7. C

    1985 390 line 1 issue

    I did that as well should have mentioned that. No matter which cord i use it trips. And the one i have on line 1 works fine on line 2. Possible bad breaker? It shows no reverse polarity. But to trip when simply switching voltage test toggle has me thinking it could be the breaker itself? Or am i...
  8. C

    1985 390 line 1 issue

    Have an 1985 390, this past weekend i went to hook shore power to the boat, as i am on the hard im close enough to the dock to run power. Line 1 kept tripping main breaker if i tried turning any of the breakers on. even when i hit the voltage test switch it would trip now i can close the main...
  9. C

    Official 390 E.C. Thread

    Have an 1985 390, this past weekend i went to hook shore power to the boat, as i am on the hard im close enough to the dock to run power. Line 1 kept tripping main breaker if i tried turning any of the breakers on. even when i hit the voltage test switch it would trip now i can close the main...
  10. C

    1985 390 cabin door key

    Thank you for the replies. I will give Jack a call.
  11. C

    1985 390 cabin door key

    I have one key for the cabin door. Its a half moon shaped keep does anyone know where i can buy at least 1 more? Any help is much appreciated
  12. C

    Sewage

    God only knows if it actually is treating properly. I would prefer to install a holding tank and install the pump out fitting.
  13. C

    Sewage

    It says in the manual that this year was available with a holding tank or the tdx system. Which that is down in the engine room
  14. C

    Sewage

    With a pedal. This has been a dock queen boat for years,
  15. C

    Sewage

    I thought the same thing. Unfortunately i dont have any pics of the toilet. And the boat is 2.5 hours away. Im hoping this weekend to go down.
  16. C

    Sewage

    Have a 1985 390, it has original sewage system. No holding tank or no way of getting pumped out. I want to remove this system and add a holding tank with the pump out fitting. What all is needed for this job. What pumps/macerator is needed? I dont completely understand this system as of yet. Any...
  17. C

    transmission question

    my dad has a 1982 360 ec, he has clicking sound on his starboard trans. my questions are for one, can you remove the unit without hauling boat? 2nd does this sound like a reduction issue or the trans itself? thanks for any help
  18. C

    1985 390

    Ok thank you
  19. C

    1985 390

    Do you happen to know tank dimensions?
  20. C

    1985 390

    Anyone encounter large amount of water in center bilge with the water tank? After i emptied the bilge today i began checking to see if this could have been rain water? Or am is it in need of a water tank? Anyone ever have a similar problem? Id greatly appreciate any help.
Back
Top