Search results

Would you be able to snap a picture?

Anyone?

I didnt have any issues with engine tempand etc. But I get a 2 beep alarm every minute or so. I bought the techmate pro plugged it in and received a 36 fault code sea water high block pressure. I replaced the impellars in alpha 1 gen 2 thinking this was the issue. Both impellars were fine but...

I will look into it and measure temp but the manual stated it could be low voltage or my fluid levels but I checked them all and are perfect. The needle never moved to show a rise in temp on either motor.

How did you resolve it? The service manual says low voltage or fluid levels which it is not they are perfect and temp is right on. If it a water sensor i will change it but I would just like to know before i buy everything under the sun.

Woulsnt that create beeps instead of a continuous alarm. Its only at 3000 rpm or more. I did read it could be voltage.

After a great weekend working on the boat and using it for 3 days, I have come to the conclusion that its a good vessel. I installed a new remote cable and made the correct adjustments and works perfectly now. When my port engine controls were impossible to dock cause of the force that I needed...

Well we are in the Sea Ray 280 Sundancer family now. We just purchased a 2002 280 Sundancer DA and spent our first night on it last night. I am sure I will have many questions and already have learned some cool tricks and fixes reading through this thread. One question I do have is my port...