Genuine Mercury Smartcraft DTS 4 Way Junction box. This is a used factory original equipment part, not aftermarket. It also comes with a connector to expand to another junction box and two plugin dust covers.
Asking $45.00 US will ship from Canada
Hi All:
I had the plastic end of my heater hose (Red Uniflex 1/2" No. SF-858) split when disconnecting for winter storage. I thought I could just buy a new end and cut the old one off but alas, nowhere can I find a tight fitting end to re-insert into the hose end with a 1/2" female swivel...
Has anyone else had sh__ty luck like me with the Jabsco water valve that controls water in and out at the stern hookup to shore water. Every summer I have to replace one or two at $60 a pop. If you even slightly move the hose where it connects in the aft cupboard it blows the gasket inside the...
I have twin 350 Mag MPI's with B3 outdrives. Over the last couple of summers on a couple of occasions when I went to power up to go on plane (which I do slowly, not just full throttle from idle) the engines over revved and I went no where. I immediately pulled the throttles back to idle and...
Does anyone in the Trenton N.J. area recognize this boat. If you do and you know the owner you might like to let him know that I have tried several contacts with the broker it is listed with to get more information on the boat. No response whatsoever. Glad I'm not selling mine with this broker.
Would like some opinions and recommendations on underwater lights for the stern. I don’t want to break the bank but would like something with quality and RGB colours.
Thanks
Has anyone found a galley faucet for updating the standard one supplied. I am especially interested in one that is reasonably priced, functional (hot/cold), and one that the nozzle actually fits over the hole in the lid on the sink.
Any and all suggestions would be most welcome!
Hi all. I have a 2004 320 SR DA that the hinges on the toilet seat snapped. After hours of searching to find the actual site for Dometic Sealand I gave up relinquishing my efforts to purchasing a standard set of hinges from West Marine. Luckily all screw holes and hinge lengths match. My...
Hello All:
I have a 4 port Smartcraft junction box (shown below) at the helm going to my present guages. I want to install the Vesselview Mobile device and do not have any ports available on the 4 port unit. Can I just purchase a Smartcraft 6 port junction box and swap it out, or is there a...
Hi All:
The picture shown is of a friends Sea Ray that was stolen last night (Sept 26, 2017) around 5pm from the Gananoque Municipal Marina in Gananoque, Ontario, Canada. The boat has recently been purchased by my friend and his wife and they had just completed upgrades etc. The boat also had...
Hi. This may sound stupid but are the fuses in the Electronic Interface Module changeable. On my 2004 320 Sundancer below the helm there is a panel with what appears to be fuses with rubber coverings sticking out from each one. if these are interchangeable, do you just pull on the rubber till...
I have a broken battery cable clamp that is a "T" style in that the cable connects to the 1st battery and then continues in one length to the next battery. Anyone know where you can get one of these inline "T" clamps. I've searched all over to no avail.
Hi All:
I posted this on my isolated "320" group and got no response whatsoever, so I thought maybe someone over here may have done this and could provide some answers.
Last year I upgraded my chartplotter from the original to a Raymarine C95. All went well and I really enjoyed the new model...
I have two Acculift MQ347's that lift my hatch.. As of late the one on the port side extends 1.5" more than the one on the starboard. Actually, since I have never measured their extension distance it may be the starboard side just does not go up as far as it should. My point in this is that...
Okay all you anchor enthusiasts, how the heck do you anchor overnight, leave your anchor light on, and avoid six million little f#%*g bugs all over my nice clean deck and canvas??? AAAARGGHHH Captain!!
:smt021
I am receiving an alarm on my Mercury Smart Craft that says, "Trim CKT Low" and it indicates the Port Side. Anyone have experience with this issue and what is it actually telling me?
Thanks
Bill
Luckily the two people on board this boat were rescued without injury,.............can't say so much for the boat!
http://www.ctvnews.ca/video?clipId=717416&playlistId=1.2589690&binId=1.810401&playlistPageNum=1&binPageNum=1
I have a situation that demands a lot of use of the toilet on board. I find that it uses my fresh water supply very quickly while cruising or at anchor. I was wondering if anyone has thought about disconnecting the fresh water supply line for the toilet water supply, and interfacing it after the...
I have recently added a new C95 Raymarine MFD to my electronics setup and would now like to add AIS. I'm curious if anyone else has added this and in what format or fashion you did so? Standard Horizon has a VHF GX2200 that has built in GPS and AIS for around the $400 mark. Raymarine on the...
I am sure I read somewhere on here within the last year or so how someone setup a way to provide heat to the deck area around the helm while running, during the cold weather. I cannot seem to find that thread. If anyone has that info I would appreciate the thread link.