I have a 2007 Sundancer 310. The clamshell vent cover on the port side took a hit and needs to be replaced. Two of the three xmas tree retainers are broken off flush. May I just push them through or do I need to extract them. If extraction, any suggestions. Thank you.
I did find a source for...
I have a similar situation. My question is two of the three xmas tree retainers are broken off flush. May I just push them through or do I need to extract them. If extraction, any suggestions. Thank you.
I am trying to remove backrests for cockpit seats to reupholster. Part numbers from parts manual.
#1 Part 1848252 Backrest for aft seat, (faces forward)
#17 Part 1848246 Aft facing seat.
The parts manual shows they lift/slide up to remove. The question is whether there are any fastenings that...
2007 310 Sundancer. I am removing the hose from the toilet to the waste tank. Pulling from the stern end so I can follow with the new hose. It seems stuck. Any suggestions beside a come a long. It seems to be installed through a solid pipe . Removed clamps that can be seen. Cannot see any clamps...
My boat is a 2007 310. I would like to order a swiveler but am not sure of the rail size, my old eyes or high school math. My circumference is 3.25 +/- and divided by pi I get 1.03. Do I order 1' or something next size up.
Thanks for any info.
I have a 2007 310 Sea Ray Sundancer with factory installed trim tabs. HIN SERT9863A70731ODA1329 with v drive, and 2 350 Engines.
I have a Garmin GPS Map 7600 installed and a Mercruiser Vessel View 7 installed. There are trim tab switches on the dash but no indicators.
What do you have...
I have read posts about these hatch problems. I have a Sea Ray Sundancer 310. The front hatch has an intermittent leak. A repair person suggests permanently gluing the hatch so it no longer opens. It seems to me this is not a safe approach. Is it safe to glue the hatch shut? Does this render the...
Greetings,
I am working on purchasing a Sundancer 320 or 340. Our club has a limit on length and measures this way –
1. Drop a plumb line down from the transom drain plug.
2. Drop a plumb line down from the bow, excluding the pulpit/winch.
3. Measure between the two.
Can anyone...