Search results

Need help removing seatback cushions. On the starboard forward cushion I can find the lower bolts but not finding any on the top. The forward left corner is still very tight. Opened up the area with the battery switches and didn't see anything. I removed cupholders and used phone to video...

I've got an '03 Sundancer 320 with 350 Mags and need to replace the hot water heater. I know the port exhaust manifold must be removed. I've had a few quotes at $1400, $1900 and $4900. First 2 bids are with the boat in the water and 3rd they want to haul out with 25 hrs of labor. How many hours...

I have to replace a Parker Skinner Fuel solenoid (see link below for picture) and it came from Sea Ray with a Delphi sealed (male) connector. Both wires in the connector are the same with no distinguishing marks and there are no indications which is the power for hooking up. Only identification...

Does anyone have any experience or info on using an aluminum RIB with a Hurley H20 davit? Thanks in advance.

Looking for a recommendation of good/reliable installer for a Hurley or similar davit on a 320 from Seattle to Anacortes. Boat is currently at Shilshole marina and will be moving north in the next few weeks so I could go as far as Anacortes for the install. Thinking of putting on a Hurley...

I am curious what other 320 owners have for their fresh water pump. I have to tap mine to get it to run and then it stops when faucets are closed. The installed pump is a Par Max 4 40 PSI part #31620-0092. On the label it states a 15 amp fuse/breaker required. I looked at the wiring diagram...

Hello All, I am need some help diagnosing RPM problem. After about 1.5 hours of cruising at different RPMs (3800, 3400, and 1800) the starboard engine RPM dropped off from 3400 to 2800 and fluctuated, noticeable power dropoff. Starboard ran about 100-150 higher per the sync gauge but engines...

Need help on deciding best type of davit to put on our 320. Any suggestions on a davit and dinghy combo, pros and cons, and cost? Thanks in advance.

I am currently in the process reviewing survey results on 2003 Sundancer 320 with 200 hrs on v-drive with 350 Mags, 18 LH/RH 19 props. Curious what others experience with similar boat. Here are some of the observations. 1. What is normal engine temp. Engine temp was 175. Normal? 2. Engine...