Search results

Check out spradling marine brilliant white vinyl. I am having some of the upholstery on my 90' 270 redone and that color was a good match.

Mike, I bypassed it on Saturday and the lights now work. The only problem I have it the ground noise but I will fix that when I change where I have the Head unit grounded.

I bypassed the black box and connected the Orange wire from the switch and the blue going to the gauges together and the gauge lights now work. However I now have a ground issue somewhere because something is backfeeding into the stereo when the dashlights are on. I just installed a clarion...

I want to assume that if you power the blue that goes to the gauges you will have constant 12v instead of being able to adjust the voltage 10v-32v dc

Spectrumcolor.com I believe has colors list by the years they were used too.

Does anyone have any advice?

I emailed searay customer service and gave them my hull id number. They responded with the 2 colors of gel coat used in my boat, the manufacturer and the part number. They also recommended spectrum color to get the materials I needed.

Contact searay with the hull id# and the can give the color to order through spectrum. I just did it a couple weeks ago

Can the dimmer be bypassed in 90' 270da? My old 87 Sorrento s24 didn't have a dimmer. And my cruisers has a switch that has 2 settings for brightness I wasn't sure if I could jump the blue wires together and bypass the black box.

That is the option I am leaning towards I just hate to spend over $300 on the whale gulped ic. We don't use the shower now but I would like to have it functioning without any odor if we choose to use it.

My only worry with a Rubbermaid container is them not being air tight.

The boat is a 1990. I was hoping someone with the same year may have a solution for. The problem I am running into is finding a water tight container that is not wider that 7". I found a todd 3 gallon fresh water holding tank but once you add the access port, fittings and bilge you have as...

Feedback from another member has led me in the direction of a missing key panel for the macerator to discharge overboard. Which I am not worried about seeing as how I boat on inland waters. Now I just need to figure out what to do with the hole that is there.

I am trying to figure another option other than draining the shower in to the bilge under the aft cabin. The problem is I don't have the width to mount the standard size shower sump box. Any input would be greatly appreciated.

I'm 5'10" also and feel there is plenty of room in my 90' as for accommodations how many people will you be overnighting with? I have 3 kids so the dinette is perfect for my family. The cockpit layout isnt terrible however my wife enjoys laying on the sunpad of our other boat so I am having a...

I have a 1990 270da and there is a panel or switch missing in the head. It is to be mounted to the right of the exhaust fan switch I found wires in loom under the sink but I have not chased them yet. Any insight as to what is missing would be greatly appreciated.

I pulled the helm bench out today. There are 6 screws that can be accessed through the aft cabin that secure the unit down. You will need to remove the speaker on the starboard side in order to access the bolt that secures the backrest that to the side trim. The back and base needs to be...

I'm looking for some how to advice on removing the arch on my 270da. I need to get it in to a garage to do some paint work and it will not fit with the arch on it. Any advice would be greatly appreciated.

Did it release just the backrest? Or do I need to pull the whole base?

Where exactly are the fastners that hold the backrest in place? Am I able remove the backrest with the helm base in the boat? Any advise will be greatly appreciated I have the rear facing bottom and the helm bottom out of the boat aready