For those in the Cleveland, Ohio market, my son is in the detailing and shrink wrap business, (Krystal Klear Detailing). He would shrink wrap a 37' Sundancer complete with the frame, vents, etc. for $481.00. If interested you can e-mail me at propdev110@aol.com
After going through a lot of time and trial and error thinking that I had a vapor lock issue with my engines, realized that the problem was the low speed mechanical fuel pumps. Replaced them on both engines and that cured the problem and runs great in any and all weather conditions.
I just disconnected from the switch the horn up front, and installed a double trumpet electric horn on top of the radar arch. I looks great and is loud as hell.
I had the same thing happen to me. Searched for months, could not find anyone that had them. They were only used on 1995-1999 370 Sundancers. Probably not enough were built to build up any stock, plus the boats are now 15 + years old. I finally had someone make a mold using the old broken...
I think at 27 mph I am running about 3300 rpm. Its been a long winter, so I'm not 100% sure, but i'll be in the water at the end of this week and will check it out further.
I switched to 18 X 20 4 blade props a couple of years ago. I get better low end torque, especially in reverse when backing into my dock. Mid range is better, I lose some top end, but I rarely run more than 27 mph. When I put the boat back in the water this spring I ran it wide open for a...
I have a 96 370, and there is definitely enough horsepower. I went with 4 blade props like the 380 has and it made a big difference in mid range performance and backing up. I also back into my dock and only have around 1' between me and my dock partner and it is no problem. I have a friend wit...
I believe it was $385.00 for both panels, and by the time you buy the material, cut it out and get everything labeled (etched), I don't know if you would save much.
I am going to install dual trumpet electric horns on top of the arch. If you tell me how to transfer pictures from my phone to this sight, I can send you pictures of the Sea Deck on my swim platform.
I bought the panels from Flounder Pounder. They were great to work with, everything fits like a glove. I don't think you could make it, with all of the lettering,
for less than what they charge.
Last winter I did some updating, I replaced the wood grain plastic gauge and switch panels on the dash, it now looks like brand new. I also added Sea Deck to my swim platform, which is a composite material that looks like teak, it looks really sharp. This winter I am adding trumpet horns on...
I live on the east side of Cleveland and boat out of Fairport Harbor, approx. 25 miles from downtown Cleveland. Went to the new Rock N Dock marina behind the Rock N roll Hall of Fame and Science Center 3 times this summer. Brought our folding bicycles and rode through downtown. I was a...