I've found the hole at the bottom of the arch inside the helm seat, actually there are two access holes. This side panel, I've removed the screws but it doesn't seem to want to budge, do I have to unscrew the controls and/or the trailer tilt button too or should it pull out with those attached...
I don't see any access panels on the arch with the exception of the 3 at the top inside. The side panel did look fairly simple to remove I just didn't want to try and get a huge surprise. I think that's the direction I will go, thanks for the information.
Bill
I purchased a 2000 Sea Ray Sundancer 290 that had an old GPS and Radar. Both screens are burnt out and it didn't appear the Radome was working. I purchased a Garmin 741xs to replace along with a new radome. I "thought' I would just tape new wires to old and pull them right through with no...
Ok, the AC Convertor worked fine in the driveway, and fine when I 1st put it in the water but by the time I got to the dock it quit working, no lights at all. Someone mentioned a fuse, I'm not aware of 'any' fuses that need to be checked/replaced are there fuses I should be aware of?
New to the site, going to put the boat in the Lake for the first time this weekend. May be a soggy weekend but it will give me some time to get to know the boat. Plan on taking it to Charleston and Wilmington within the month as long as there are no major bugs! Look forward to the site.
I recently purchased a 2000 Sea Ray 290, it is a twin engine model with 3 batteries. I currently have it in the drive way plugged in and was under the assumption that when plugged in it would charge the batteries? Apparently I was wrong since the 'house' battery seems to be dead now. Does...