anyone have tips or how to replace the glass in the "wing window" the window that can open and close in a 86 250 sundancer.. i just came home to find it broken .. not sure how or when this happened.. but its broken and now I need to repair it..
anyone ever take this to a glass shop? is it a...
What was the water intrusion point? Flooded bilge from rain water? Where did the water enter the fuel cell bulge area from - curious so I can protect or check my boat for this.
Some other forums have this and its more specific to the older boats then a buy sell thread.
Here is the idea.. do you have a classic Searay your parting out or need parts for? throw up what you need or have so people can contact you.
I am looking for 1 of the swim deck stanchion posts for a...
i would find the source of the water leak and then decide if your up for the project, sounds like you need to rebuild the whole engine compartment at a minimum.
what size tank do you have the 100Gal? the engine needs to be removed to even move that tank, I have always wondered how I would do it...
yea even in the locks I just use the normal like 7" ones - older boat I stress less about gelcoat issues I guess. I have been known to dock and say "eh the rub rail will get it"
in this case sounds like boat and man went into the blue, so you did well with your mayday IMO, and obviously the radio traffic operator at the time handled your call.
well done! I am always on alert for assistance to the small craft and SUP that are now always filling the channel ways in the...
I have owned two of these one major area of concern is the rear seat, has a cooler in it. the cooler drains to bilge.. or its supposed to. I have seen the seal on that drain leak right into the foam for the boat, thus rotting the floor, the stringers are reasonably well protected from factory...
I am looking for the raw water / seawater pump that mounts to the 305/350 engine block of a merc.
This is mounts near the fuel pump and is belt driven.
For a 1986 sunancer closed cooling system.
I mostly need the bracket's and mounting hardware
I just got a new to me sundancer 250 1986
the previous owner took the drinking water tank and pump out - where was the pump located and what wires ran it?
I I also have no hot water tank - I would love some plumbing layout etc so I can add it back
Anyone know a source for the aft curtain or any photos of it or could get me measurements? (Or one for sale)
I have the tubing frame for my boat but not the material - I would like to do this (asking here before I have a custom builder do it.)
Sent from my iPhone using Tapatalk