I have two oil filters and two impellers for sale. These are new and are not needed.
Quicksilver
Oil Filter P/N : 35-866340Q03
Impeller P/N : 47-8M0104229
Asking $65 shipped or BO. Paypal only.
Thanks,
Rob
I purchased two actuators but only needed one. As a result I have a new unused 24" actuator and the old defective one. On the old one, the gears are stripped but the motor is good for replacement.
I can provide pictures, just PM me with email address. I can provide the original receipt for...
In our 2010 390DA the light lens in the shower came off while under way. We noticed it on the floor and found it is glass. It had shattered with glass slivers everywhere. Not sure why a glass light was installed in the shower while there are no other lenses that are glass. The bulb itself is...
Got the boat with one 40lbs gas spring on each hatch. The hatch would not stay open. Replaced with new 40lbs gas spring. The hatch would not stay open. Each hatch with the one spring did not close squarely but did latch closed. Removed the springs and the hatches close perfectly. Saw that...
I have to replace both of mine. The parts manual indicates a 40 lbs gas spring.
Anyone replaced these and if so did they use the Attwood 15" / 9.5" 40 lbs tube?
That's what was on the boat and it will no longer hold open the hatch.
Seen a 2011 390 DA with two springs on the hatches. I am...
Trying to figure out how to start and stop the generator using the remote digital gauge.
I am assuming the generator has to be in AUTO mode for this to work.
Any input is appreciated.
The generator runs fine when starting and stopping manually.
Thanks in advance,
Rob
Looking to replace the seal on the bottom of transom door. Don't have a parts manual and search does not yield any results.
Is this seal something the previous owner added or do all of these models have it?
The one on our 390DA has deteriorated and needs to be replaced. Looking to get the...
Looking for the Mercathode controller but can not find it. I am thinking the past owner had it removed. I did find the brown and orange wires from the electrode on the BIII but cant find the other end.
Any help is greatly appreciated.
Thanks in advance,
Rob
Seeing several boats both 38's and 390's that have the transom door hitting at the top when closing. Noticed that the outside temp has an impact. Warmer temp seems to have less problems. What adjustments if any have have been made to address?
Thanks,
Rob
In my last boat I just pumped anti-freeze into the bilge pump thru hull outlet on the hull. Saw it come out the bilge pump and that was it.
Sea Ray has a one-way valve inline with the pump. How is this setup winterized?
Thanks,
Rob
38DA has 8.1L 370hp and the 370DA has 8.2L 375hp inboards with bow thruster in both.
Without comparing the details of other options in both, which one has the overall better ride and handling characteristics?
Thanks in advance,
Rob