Sorry but maybe I am just blind but where on an 07 340da with inboard 8.1 engines are the cool fuel filters. If you could send a pic then even better.
Thanks a lot in advance
Sent from my iPhone using Tapatalk
Interested in the aquaweave and want to GE a ballpark on cost to do swim platform and cockpit. I have an 07 340DA.
Thanks
Sent from my iPhone using Tapatalk
Last ditch effort to cure display issues. All signs point to piggyback board that is unseating.
So has anyone here taken one of these apart. I can find some other non-CSR forums that talk to this process but wanted to see if anyone has first hand experience.
Thanks
Sent from my iPhone using...
My c80 is going up and I don't want to have to replace the radar. So does anyone have or know of a new or used(good working order) for sale.
Thanks
Sent from my iPad using Tapatalk
Started my Genny last Sunday and got an LOC error. Figured it must be the impeller after some research here. Opened the pump housing and found impeller was destroyed. I was able to recover 2 of the 6 blades. So I found lots of references to how to flush and back flush from the cooler to recover...
2007 sea Ray 340 with 8.1 horizon engines. Yesterday about 20 minutes into a run out, the smart craft goes off and pulls back to idle. I had the engines shut down within a few seconds. Limped back in on starboard engine (that was a fun parking job, thank the lord I have a bow thruster).
Opened...
Cmd4 won't turn on when I select ON. It says there is an line fuse...but where?
As an aside, what provide electrical power to this unit.
Thanks
Sent from my iPad using Tapatalk
Need some help...first time removing belt to change pump impeller. This is a 2007 Horizon 8.1 on a 340.
Where is the belt tensioner?
Sent from my iPhone using Tapatalk
Need some suggestions...trying to remove one of the blue drain plugs on the starboard engine and it snapped off leaving the threaded part of the plug still in the engine. Has anyone had this happen and if so how did you get it out? <br><br>Thanks,<br>FD
OK...I have looked on the site but can't seem to see the answer to my question. Specifically, when I run anti-freeze thru the raw water cooling side of the engine and genny it will be pumped overboard. So is there a type of antifreeze that is safe to pump into the water.
Thanks
I noticed that the shift lever for the port engine seems loose with a fair amount of play in it when it is in neutral. Is there some way to tighten this or does this indicate a problem?
thanks
I just bought a 2007 340 Sundancer with the clarion cmd4a. It's located with the Ac and dc control panels in the salon.
I want to access the wiring at back of the unit. I look at the install manual and it shows how you remove the screws mounting the unit...I did that and the unit pulls out of...