Search results

Does anyone know where to find the fuel sending unit on a '96 250 sundancer? I've taken the panel up in the aft cabin and nothing but the top of the tank is visable...I'm thinking it's in the bilge, under the white plastic tank but not sure and hate to just start taking things apart

Hi guys, I have a 1996 250 sundancer with 7.4 and a weber carb....I recently bought this boat, had the carb rebuilt by a local, reputable builder, did major tune up, made sure timing is right on and it sucks to start......when cold i pump the throttle 5-6 times and have it full open when...

I have an '89 sundancer 300, does anyone know what wood that is? it was apparently clearcoated with something...maybe from factory but its ugly now and most of the clear is gone...i want to refinish but not sure if its teak and i should clean and use teak oil or?

just went thru my 5.7 in my '89 300 sundancer, got it to run but need to adjust the rockers and theres just to much in the way to do it running...I remember there was a way shown in a manual that was something like...."with no1 up at TDC adjust no 8 exhaust and intake then rotate 1 turn and do...

I bought an '89 300 sundancer with twin 5.7's....it wasnt running when i got it and have been working on it... i pulled the starboard outdrive to replace the impeller and seperated the unit to access the parts but never took notice of the direction when in forward.,,, i looked on you tube and a...

I just got an '89 300 sundancer.....i'm replacing the water pump and impeller in the mercruiser outdrive, i have the unit split and am putting the new parts in and while in gear, i can barely get the lower unit to turn in either direction when in gear...it spins free in neutral but in gear i...

hhave an '89 300 sundancer with 5.7... i had to pull the motor to do some repairs and at the same time replaced the gimbal housing, and gimbal bearing...i used the original inner plate. I can not get things aligned, i have the alignment tool but it wont go into the splines...looks like it leaves...

my 1989 300 sundancer didnt have a thermostat in it and i want to instal one...it has a mercruiser 5.7 and i ordered a 54mm 140 degree but the diamiter it to big......there are 3-4 different kinds listed for 5.7 motors but which is the correct one?

how do you get the motor into the 300 sundancer????? call your Amish neighbor and have him bring his fork lift over

I'm replacing the bellows on my "89 alpha 1 gen 1.....(this job does suck) I have everything apart and am cleaning all the surfaces and have a question..... on the large bellow, the one that the drive shaft goes thru, which end do you install first, the end that goes against the gimbal housing...

I just picked up an '89 300 sundancer, it came with a tri axle aluminum trailer...I have a few things to do to it before its ready for the water but was wondering......can you launch a boat this size at a regular boat ramp with your truck or is it to big and I would need to go to a marina with a...

my trim pump/cylinder on my '89 sundancer 300 isnt working on the starboard outdrive.....you can hear the motor spining but it doesnt seems to have anyresistance/pressue on it like the port side...just has a "free wheeling" sound to it...seems like whatever makes it pump fluid isnt creating that...

what size gen come from the factory