Search results

Hi folks looking for some advise... i have a 2003 320 with 6.2 mpi’s.I had replaced both manifold and risers at the start of the 2015 season (spring) and just had a mechanic recommend that I replace them... I always new to watch my temperatures when running and that was a good tell tale of when...

If I changed the plugs 140 hours 2 seasons ago do I need change them as well or should they be good? Sent from my iPhone using Tapatalk

Great info gents! Thank you!!! Sent from my iPhone using Tapatalk

Whenever I open the dip stick to check the oil there's always a strong vacuum. Wouldn't there be water in the transmission if there was a leek and not fluid missing? Let me know thanks! Sent from my iPhone using Tapatalk

Thank you Frank I did actually have an issue with the same motor where the RPM's would be low at iddle. I had actually had the motor stall on me once or twice while pulling off the dock id i font let it warm up for a little while. in order for the motor to hold a solid idle i would have to...

Thanks. I posted on sea ray face book group and was given the following recomendations. Check: the cutlass bearing set screws the coupler bolt could be loose the props should be scanned. the engine mounts should be checked the alignment should be done. Let me know if you guys know of...

Re: 2016 Upgrade Photos (Floor-TV /Old TV Cubby /Electrical Control panel /DE-Golding PM Me if you have an questions thanks!

Re: 2016 Upgrade Photos (Floor-TV /Old TV Cubby /Electrical Control panel /DE-Golding never had smart craft.. i actually installed without the front end i used the converters to nema and im picking t up on the garmin unit i have front and center...

Re: 2016 Upgrade Photos (Floor-TV /Old TV Cubby /Electrical Control panel /DE-Golding I think that that this is because the idea of it moving or bending could be an issue down the road if it were to break... i had anchored it really well so it couldnt move and the lenght is only about 3ft. let...

Hey guys, hope everyone is keeping there sanity through the winter months... this sight always helps ease the pain of the winter months... I had this really odd issue at the end of the season last year.. so id pull off the dock and immediately once the boat was at 800, 1000 ish rpms there...

looking for a 1.5 perko strainer assembly. might you have? thnaks.

Hey folks, its time to re-up on the canvas and carpet. Hoping to get some feedback befor making the purchase. Sunbrela or seamark Is ther any prefered Izenglass? Vendor preferances anyone have any experiance with the company that sels the whole set up of ebay "Harverd marine"...

Thanks guys! Sounds easy enough!

Good evening I have had my boat for 2 seasons and recently noticed that the ATF fluid was low on my v-drives during an engine room check. I have 03 320 with 6.2 inboards (obv). I would like to do a full service as apposed to just adding fluid. could someone point me in the right direction so...

Hmm ok thanks I know what sensors your referring to. I changed them last year... so even though the label on the gauge reads "coolant pressure (psi)" you think that's for the raw water? Not the actual coolant?

Good evening, i think i may have stumbled on an issue that hasn't fully presented itself yet... I have a 2003 320 DA with 6.2 Closed cooled blocks... Yesterday I was at the boat prepping for an upcoming trip. (Barnegate NJ to OCMD back to cape may then AC ) I was flipping through my...

Good evening, i think i may have stumbled on an issue that hasn't fully presented itself yet... I have a 2003 320 DA with 6.2 Closed cooled blocks... Yesterday I was at the boat prepping for an upcoming trip. (Barnegate NJ to OCMD back to cape may then AC ) I was flipping through my...

Ray Teel did my props as well I have 17x18 hytourqs I think... How much did the 4 blades run you if you don't mind me asking.

Re: 2016 Upgrade Photos (Floor-TV /Old TV Cubby /Electrical Control panel /DE-Golding Thanks guys, appreciate the kind words! Had a blast with these projects. The floor is made by lonseal

Re: 2016 Upgrade Photos (Floor-TV /Old TV Cubby /Electrical Control panel /DE-Golding Solid core