Search results

  1. F

    Worn cable (steering?) on 2010 Sundeck 220

    Hello, Per the attached pic I discovered this worn cable, circled in red near the engine bay. The rear passenger cooler/storage screws over this and the plastic drain plug pushes hard on the cable, creating the wear. Is this part of the steering cable? And should I replace? Thank you
  2. F

    YKK zipper repair?

    Per the pics, the top of the zipper that holds the handle on popped off. Can I just snap a new little cover on that holds the handle in place? Where can I get these? Not sure size but pretty big canvas zippers. The cover flew in the water but I have the handle. It will be tricky to have to...
  3. F

    Canvas loop snap repair/kit?

    Wow, thanks all! Problem solved
  4. F

    Canvas loop snap repair/kit?

    Hello, Per the attached pic I'd like to repair this loop snap myself. I don't see any sort of kit on Amazon and or West Marine. Appreciate any advice. This is on the back of the boat and now flapping a bit. Thank you
  5. F

    Airmar Smart Transducer not working

    I have the plug. The boat is also on my boat lift so I don't really need the plug. The Garmin back bone plugs into a cable coming off the engine. Depth and temp data display on both the Smarycraft and Garmin. I'll take closer look but hope I don't have to go to the gauge in the helm. I...
  6. F

    Airmar Smart Transducer not working

    Thanks for the contact. The depth is shown on the original SeaRay helm gauge and also an aftermarket Garmin plotter.
  7. F

    Airmar Smart Transducer not working

    Hello, I have an Airmar part number 888828A21 that isn't reporting depth anymore. The screen just shows zero. The temperature is working. This is in a 2010 Sundeck 220. I've attached a couple pictures. How far back to the wires go, clear to the helm? Or is there a plug nearby in the...
  8. F

    Oxidation Revisited

    I've read the majority of oxidation solutions here, watched YouTube videos, researched etc. and decided to buy a Porter Cable orbital, Hexlogic pads and used Starbrite premium cleaner wax with the orange cutting pad. This hardly phased the topside oxidation you see in the picture. I made...
  9. F

    2010 220 Sundeck throwing engine faults

    Hello all, I have a 5.7 L Merc with 419 hours in the Sundeck. Early this season I was occasionally getting a fault that would put the engine in guardian mode. The DTS display would say "Engine throttle level not operating properly". After shutting batteries off it would reset and run fine...
  10. F

    Alternator output on 2010 Mercury 350/Sundeck 220?

    Hello, I'm adding some additional LED xmas lights to the boat this year for parades etc. You can see in the signature below I have two long runs of LED lights that draw about 10 amps total. These have been fine for long runs including idles for extended periods; 6 hours. I want to add more...
  11. F

    SeaRay parts? table with mount and arm

    Hello, Anyone know of a great SeaRay parts department that has good pricing, help and shipping etc.? I need to put in a table in my 220 and I'm not super crazy about my local SR dealers. Thank you
  12. F

    Dometic toilet leaking at level indicator

    Yes I just bought a replacement bottom tank. Anyone ever put the larger 5 gallon tank after using the smaller tank? It's three inches taller and my wife already hits her head with the shorter tank, don't think larger will work...
  13. F

    Dometic toilet leaking at level indicator

    Thanks, looks like I'm putting a new one in. I have the line out and vent line connected with metal clamps. When I reconnect the lines, do I need any sealer beyond the metal clamps or just tighten the metal clamps?
  14. F

    Dometic toilet leaking at level indicator

    Per the pic, the toilet is leaking at the seam. And the leak is obviously waste. It's very slow but needs to be fixed. Will I need to replace the whole thing? Any chance Dometic will replace? It's five years old... Appreciate any advice.
  15. F

    Plastic angle brackets?

    Any idea where I can buy these? I'm putting in a shelf and need some more of these. Thanks!
  16. F

    Garmin chart plotter 547 NMEA engine data not in all screens

    Hello, I recently installed a Garmin 547xs along with the Mercury NMEA Gateway and network. The data is coming over, as you can see in the data only pic I have the engine data coming over. However in the map view, some of the engine data isn't coming over: RPMs, fuel flow and level. I've...
  17. F

    BBQ installed, thank you

    Great! Where did you put it? Let's see a pic
  18. F

    "Flush" install to non-flush surface

    Ok, I finally got this in. The NMEA data is great as are the maps. I used both the RAM windshield post clamp and a 1" ball connection at the base. It's rock solid!
  19. F

    Shield drain wire on NMEA backbone power?

    Thanks guys, I'll ground it. Appreciate it!
  20. F

    BBQ installed, thank you

    Its a log boom for boats to tie to for opening boating day parade and crew races.
Back
Top