This is a pair of Nibral Teinbridge props off of a SeaRay 340 SDA. After purchasing a new set of props, these were sent out for Propscans and moved to "spare prop" staus. They do have some pitting on the back sides and while they would work just fine for a good set of lower budget primary...
Unfortunately, no. It is an 8m6001946. And now that I look, I believe I mis-spoke before. It looks like this is speed and temp. Depth was a separate transducer.
I am not sure on that shaft size. I did itially looked mine up in the Searay parts manual for my boat, but I’m not sure they have a parts manual listed for ‘83’s. I don’t mind holding it for a day or so for you. As for the prop puller, it probably won’t pull the 3 blade based on the design. I do...
TechMate Pro is Rinda Technologies' new generation diagnostic scan tool built for professional marine service applications. With over 25 years of experience in designing and manufactuing marine diagnostic equipment, Rinda Technologies designed the TechMate Pro from the ground up with marine...
I am selling my Strut Pro tool. This tool makes changing out the Cutless bearing easy with no need to remove the shafts. I am also including the optional prop puller plate that will turn this tool into a prop puller as well. This has only been used to change the Cutless bearings on two Searay...
Absolutley. If you look in my picture, you can see 3 nuts and 3 studs coming out of one side of the EIM. These are where the main power and ground feed pass through. Once I had a new EIM in hand, I figured I would open the old one up and look for anything obvious. All 3 of the nuts were...
This is a SeaRay Headliner material that has been discontinued for several years. This was used on many of the early to mid 2000's boats. I paid $22.95/ yd (36" x 54"), will sell for $15/ yard + shipping. I have about 50yds and would be willing to negotiate on purchases of larger quantities.
This is a new, in the box, replacement cockpit sink for the 340 SDA. At one point these were discontinued, but i believe they may be available again. I was just given a list price of $248.04 from the dealer. Mine is brand new in the box. You will need to drill the hole for the drain, as this...
At the end of the season I thought I needed a new rear EIM. Apparently these are discontinued and no longer available from Searay. I ordered one and paid dearly for it, but was able to resolve my issue without replacing the EIM. I now have a new EIM that I would like to sell. This was...
I purchased this as a Kohler Sea Spares kit, but added quite a few parts and the service manual. This is over $200 in Kohler parts.
Kit includes:
Durable Watertight Container
5E and 7.3E service manual
Brushes #239282 (2)
(5) 223316 - 10 amp fuses
(5) 262389 - 25 amp fuses
Fuel Filter #...
I preordered the new Optio flow sensors. They do not integrate into a MFD at this point, but are bluetooth, with an internal battery and work in conjunction with an app they have developed. I'm glad you mentioned the generator, as I had ordered one for that as well. After you mentioned it I...