268 Stove Question.
I would like to change the S.S. covers under the burner elements.
I tried popping them out with no luck.
Thought id ask before renting the jack hammer.
Thank you,
The Magic Bus
Hello,
Changing my starter on single 454 motor again.
Ya'll have a preference on mfg for your starters??
Plus its a true pain to change these. I can't imagine a boat with 2 engines to
complete this ....
Thank you,
The Magic Bus
Hello Crew,
Looking for some advise.
Last year my J Hose split on the front of my motor, single 454, pumping water into the engine compartment while running on plane.
Nursed it back to dock and trailered it and drained.
Replaced Altenator, starter and had to change oil n filter 3 times until...
Hello,
Looking for recommendations on replacing my Fridge....Norcold TEKII DE251.
This thing cycles when it wants to AC or DC.
Davy Jones can have it......to keep his beer cold.
Thanks for your help
The Magic Bus
Lake Murray SC
**** UPDATE *****
After letting the engine compartment dry and a healthy coating of WD-40, I made out pretty well.
Starter and alternator where serviced and ok, batteries ok, I will check the hot water heater this weekend.
Changed Hydraulic fluids in trim and outdrive tilt pumps.
I have changed...
Water did get to the step down pump, maybe 5 gal.
Pullng the plugs will be done, I'll check distributor cap as well.
Was on Lake Murray, so fresh water.
I would like to say "Thank you" to all that replied, your an awesome bunch !!!
Hi Gang,
I had some bad luck this weekend and looking for some advise.
The "J" hose on the water pump split (454Motor) and auto bilge pump shorted or never came on.
Water to the valve covers and still running, nursed it to the ramp and trailered it.
Drained well...... now the work begins ...
Thanks for the reply.
Not sure what I hit, but cracked the lower bearing case, and weeping water at propeller bearings.
Still runs and shifts fine...but I would like to replace the lower unit.
Any experience SEI vs Mercruiser ??
Hello,
New 268 DA member to the forum.
1988 DA with 1 motor 454, 330 HP
Need some good advise, as I just blew my lower end of my Alpha1 Gen1 out drive.
I'm looking to replace just the lower end. OEM is very expensive, and SEI has mixed results.
I believe the ratio is 32/1 ??
Any advise or...