Search results

Todd, It's not so much the Surveyor that will ding you; it's the Coast Guard. Missing Decals can come with a Ding that may cost $$$. GQ

Southco locks and closures are also used on most RV products. I don't know that they are discounted anywhere, but you might try the Camping World website. There are also several other RV online sellers that probably carry the Southco Brand.

Will Do you plan to keep the boat in salt water full time or will you be able to remove it when you are not using it? If you plan to keep it in the water full time, I assume you have V Drives. I'm sure you will get plenty of comments, but my feeling is that if you can take the boat out of the...

Todd The one on the left looks like an 1156, single filament. They were used in tail lights on older cars. I'm going to be at my boat tomorrow, and I'll check. I think I have some 1156's around from my car restoration days.

You said the door came out easy. Did you have to remove the helm?

The Harborage Marina in St Petersburg has a lot of live aboards. Quite a ways from Ft. Meyers though.

Todd. I just serviced my generator, and the anode was on the bottom of the heat exchanger. May be harder to see on your boat with the Generator against the transom.

Almost any "contact cement" will work. It is available in small bottles with a built in brush.

I have a similar situation with my 320. I talked to several Tech's including a Mercruiser (supposed) expert. The net result is that you can use the other steering pump........but you must disconnect the starboard side and connect hoses from the port engine to the steering actuator. You then...

I have a 320 with outdrives and I find it easier to dock using only one engine. As noted above, there is little two engine handling advantage with IO's.. Of course I kind of cheat..........I installed a Bow Thruster.

Rob, i'm not much help, but thought you might want to know that you are not alone. I have the same boat, but with stern drives, and it does the same thing. Fortunately mine only seems to do it when the engine is not fully warmed up. By the time I clear the marina it usually is OK. I assume...

Todd; My Cockpit refrig. was replaced when I bought the boat, but with the original black. Stainless would look neat. If it is truly stainless (not Stainless Paint) it should hold up. By the way, do you have any idea when our boats will be moved back inside the building? Been sitting outside...

I'm sitting on the floor right at Harborage Marina. Same boat as yours except outdrives. I watched the guys install your floor. You're right, it was labor intensive. I'm working in my boat (Patsy Lou) a couple of days a week. Hope to meet you there some day.

I also just bought a 2005 320, and have a similar problem. I can not find any info on where to get the unit repaired, or where to get a replacement. Mine works.....kind of, but the remote will not work at all. Tried new batteries....to no avail. I hoped someone would respond to your post...

Nick Been following your speedo question, but no replies. Have you found the speedo pitot? I have the same problem, and can not find the pitot. Gary