Search results

Ok, after two years figuring out why my generator would start then immediately shut off, I thought all was well. I have a different issue. Now when I try to start the generator, the green light on the circuit board blinks rapidly, the fuel solenoid also clicks as well as the fuel pump ( at least...

Generac Power Systems Marine Circuit Board. PN 0936420SVR Assy 93642 Rev E. Purchased a board but that wasn't the issue. I have the receipt from Flight Systems in Mechanicsburg, PA where they tested it. They retail for $299.99. I am asking $195.00. Contact Leon at 717-329-0316.

I have an issue with the generator stating and running for a second or two then shutting off. I can look down and see the fuel stop flowing. I tried pouring in a little gas but it didn't seem to run any longer. I pulled off the fuel line and I do have fuel pressure. Any thoughts? Its an OS-5.0G...

I am looking for a cockpit sink for a 1991 310 sundancer. Mine broke trying to get it out to remove the side panel so I can get it reupholstered. The sink is about as flimsy as it gets!

. Oh yea. So far three batteries, charger. The Bimini tops were in the cabin, so they are fine. I suspect all/most of the dash switches are bad. The snow and rain got on the dash. Good thing is he had the outdrives in his garage, and I was able to manually turn the engines over. If the fuel...

I have a 1990 270 Sundancer with twin 4.3L engines alpha I outdrives. I want to switch to stainless props. Any suggestions on what size props would work best? Thanks

Thanks. The boat used to be beautiful. i'll have a lot of elbow grease in hr. New upholstery, new canvas, etc. If I can get the engines to run, then the rest will fall into place.

I forgot about Mystery Oil. Good call!

I asked the same thing. When I go to get it, I'll ask the guy running the lift

I just purchased my brother-in-laws 1990 270 SunDancer. Been on stands for 10 years. Engines were flogged, and outdrives removed and stored indoors. I plan on spraying WD40 down the cylinders (removing plugs) for a couple weeks before I even attempt trying to rotate the engines manually. Any...