Search results

  1. S

    Someone to rebed porthole windows 98 250DA

    Does anyone know someone in St. Pete - Tampa Bay area that can quote me to rebed all 4 porthole windows? Or a rough idea of what this should cost? I called someone local and he was unfamiliar with the boat and wanted me to send pictures. Not confidence building. Yes, I have seen the how-to...
  2. S

    Quote to re-bed portholes

    Looking for someone to do all 3 porthole windows, and screens on 98 250DA in the St. Petersburg area / Tampa area. After tropical storm Colin brought 2 days of constant rain, my cabin floor is puddled. From other threads here it appears water leaks in Bergen window and wall and runs down...
  3. S

    Pulsating dash lights

    I rarely cruise at night but I recently discovered that my dash/ instrument lights pulse with the engine running. At idle the glow steady, but as rpm increases, they blink rapidly. Not on off, but bright & dim, pulsing. Weird. And annoying. Anyone have similar experience and solution? Thanks...
  4. S

    Bilge blower check

    Note to self (and other stern drive boaters): Make sure your bilge blower duct is actually connected to outlet vent. Mine came loose while I was changing out waterpump impeller. I guess old plastic zip ties do break. An easy check during your 4 minute blower purge before engine start would...
  5. S

    Drilling screw holes in the bilge

    I have a 98 250DA. Replaced battery with larger size so of course I had to install larger battery hold-down and drill some holes to mount it. I am also replacing wall mounted battery charger which has different mount hole pattern than previous. My question: How thick is the wall and floor...
  6. S

    Experience with 12 volt air conditioners

    Hello, I recently purchase a 98 250DA in Florida. It has no Air Conditioning, or genset but does have shore power hookup and a 20amp 12vdc output marine battery charger. I am considering the Marvair 5000 btu 12 volt unit. This has the brushless DC motor-compressor. It pulls 30amps nominal at...
  7. S

    Cabin Hatch Riser arm replacement

    I have recently purchased a '98 250 Sundancer. One of the hatch arms was broken. This is a Taylor Made Ultra II 20x20 hatch I purchased two arms and removed the old ones. I found that the arms are secured to the frame of the hatch by a blind rivet which is installed FROM THE OUTSIDE?!! I know...
Back
Top