Search results

  1. J

    temp alarm, oil at 0 PSI, but level full?

    Does anyone know if there is a trick to pulling the pulley off the seawater pump shaft? I got the pump out yesterday after a couple contortioned hours and some bloody knuckles, only to find that I cannot get the pulley off, even with a removal tool. It has some rust, but it doesn't look like...
  2. J

    temp alarm, oil at 0 PSI, but level full?

    Thanks John- I hope you're guess is right. I'll let you know...
  3. J

    temp alarm, oil at 0 PSI, but level full?

    Thanks Tom- I don't have Smartcraft, yet...
  4. J

    temp alarm, oil at 0 PSI, but level full?

    First I would like to say thanks to the members that answered a couple questions when purchasing our boat a couple months ago. This site is great and I look forward to having enough Sea-Ray experience under my belt to be a contributor in the future . Our new boat has been great. She had 311...
  5. J

    Inspect Bravo III before purchase?

    To all that replied- thanks much. The boat is out of the water. Drive "looks" good. Don't see any corrosion other than on anodes. SS props also look very good. tcontic- did your marine survey include a sea-trial? I've been told to do some figure 8's at 1400-1500 rpm with engine hatch open...
  6. J

    Inspect Bravo III before purchase?

    No- what will be done in the survey regarding the drive?
  7. J

    Help! How to inspect BIII drive?

    I am making an offer on a 2002 240SD today. Engine has April compression check (175/180/180/180/176/175/185/180) and has 311 hours. Drive/props looks good and offer is contingent on sea-trial tomorrow. Is there a test to check the drive??? Any advice would be most appreciated!
  8. J

    Inspect Bravo III before purchase?

    I am making an offer on a 2002 240SD today. Engine has April compression check (175/180/180/180/176/175/185/180) and has 311 hours. Drive/props looks good and offer is contingent on sea-trial tomorrow. Is there a test to check the drive??? Any advice would be most appreciated!
  9. J

    cost to replace MerCruiser 5.7 EFI

    I am shopping hard and considering several 21-24' bowriders on the market. Anyone know what it would cost to put in all new engine and drive? How about high quality rebuild? Thanks for any info!
  10. J

    96 21' BR wood floor issues? Engine performance ok?

    Thanks Weave. Any idea what a marine repair shop would charge to replace the one section?
  11. J

    96 21' BR wood floor issues? Engine performance ok?

    Hi all- new to your group and seriously considering a boat that has been owned by a meticulous friend most of its life except the last year. Currrent owner had in water 4 times and less than 10 hours. I took boat out today for 2 hours running in St. Johns river/Jacksonville and was...
Back
Top