Search results

  1. Ethan's Tank

    Xtreme Heater XXX Heat 600w engine room heater

    Xtreme Heaters XXXHEAT Large 600W 110v Boat Engine Compartment Heater | Military Certified, Ultra-Safe, Multi-Use Boat Bilge Heater, RV Heater, Camper & Van Heater I no longer have my boat and I used it last winter. No damage, scratches, dents on unit. It looks brand new and works perfectly...
  2. Ethan's Tank

    HELP!! wet floor in aft cabin 350DA

    Wow that's crazy, sorry to get you hunting all over your shower area. The things you learn troubleshooting all these issues!
  3. Ethan's Tank

    sea ray helm starboard switch with electrical pad [brand new]

    I bought this from my local sea ray dealer, but my mechanic ended up fixing the bilge pump switch as I was walking to my boat. Unfortunately, the dealer doesn't except returns, so I need to sell this brand new part. Supposedly, these are the last few made and will be a hard item to find if...
  4. Ethan's Tank

    Ultrasonic fuel sending unit

    Magnet floats, Reed switch is working with gauge, so not sure what the issue is. I will reinstall and see if it works now. No one has in hand, except mechanical arm type and Sea trial is tomorrow. FML. I may have to go back to old style so buyer can take it home. Searay dealer told me they...
  5. Ethan's Tank

    Ultrasonic fuel sending unit

    I found them at west marine and Amazon, thanks a lot...if this fixes my issue, then next thing is the 240degree engines problem
  6. Ethan's Tank

    Ultrasonic fuel sending unit

    Thank you for that explanation, I will try your magnet idea tomorrow. Now the big question, since there is a searay dealer close-by to me, is there a special part name for this? I called them today, they looked up my HIN and told me to use a universal moeller mechanical float switch. I'm...
  7. Ethan's Tank

    Ultrasonic fuel sending unit

    What kind of boat you got
  8. Ethan's Tank

    Ultrasonic fuel sending unit

    My fuel gauge isn't working and I noticed in the searay schematic, it mentions an ultrasonic fuel sending unit. I didn't unscrew the 5 bolts, but there a black cap on the top of the fuel unit. Does anyone know how to mess with this type? I'm not sure if this is a traditional type since I've...
  9. Ethan's Tank

    HELP!! wet floor in aft cabin 350DA

    From what I remember, I think the gasket was worn down, so there was a drip leak. I put blowers on it 24/7, so the wood was stained.
  10. Ethan's Tank

    HELP!! wet floor in aft cabin 350DA

    Mine original shower bilge pump was due to that box being old and the lid was not sealing, on top of the gray water from the shower was blocking up the sump pump. I replaced it completely, new box and new pump and it didn't have any more issues
  11. Ethan's Tank

    HELP!! wet floor in aft cabin 350DA

    It ended up in the same area. I think because of the angle of the boat. So, the shower thing was completely hidden...water just appeared. The sink thing, I noticed the carpet wall under the head door was getting wet, and I'm thinking I remember seeing water flowing down the the hardwood along...
  12. Ethan's Tank

    HELP!! wet floor in aft cabin 350DA

    The water tank is a PITA since its all screw in and all custom. The pics above is the time I had to rebuild the T fitting. That is located behind the bigger fridge. If you have a shower handle leak, that's easy to get to, just make sure you have silicone on hand to reseal it. I also checked...
  13. Ethan's Tank

    HELP!! wet floor in aft cabin 350DA

    Hey there, welcome to the forum Mine problem turned out to be the shower diverter behind the shower wall. I took off the single shower handle and found one of the nuts were loose. It was a pain to find, but it definitely resolved my issue. I had another similar leak the following year and it...
  14. Ethan's Tank

    Official 330/350 (2008 and newer) Thread

    Found the schematic in the manual too
  15. Ethan's Tank

    Official 330/350 (2008 and newer) Thread

    I found a helm switch on eBay, but I'd rather wire to my acc2, just need to figure out the wiring schematic and the helm switch is a simple plug in harness
  16. Ethan's Tank

    Official 330/350 (2008 and newer) Thread

    Thanks Tom, I'm headed down there this weekend to take a look at your suggestions. Although I'm looking at some old photos of the engine room, I am trying to see what the eim is. Here are some pictures of what I am looking at when I am in the engine room. Can you let me know if any of these...
Back
Top