Did this work ok last season and not this year when you tried it?...if so, it might be stuck valves from sitting over the winter inside the pump. Here is what I would try. I would have a buddy push down or stand on the drive while you are pushing the down button. Might be worth a try before...
3/8 line......I had to buy new fittings for tank and water separator. I think 1/4" thread with 3/8 barb.
I double clamped mine.
Here is what I replaced mine with...
Thanks for the replies
I have diagnosed the problem as a intake manifold gasket....sprayed brake cleaner where intake meets heads at idle and the the engine stalled. Also did a compression test and all cylinders were between 165 to 175psi. All torn apart and waiting on gasket set now. Hope this...
I have not done a compression check but here is all that has been done:
Fresh water boat so I don't believe the bottom is fouled....it started last year and when boat was pulled for winter, bottom was clean.
New filters
Rebuilt Carb
New Fuel Pump
New fuel lines
New Plugs
New Cap and rotator
New...
Hello all....Looking for a set of 3 blade 17x15 props with 1.25 shaft for a 1987 Weekender / Express
I currently run 17 x 16 but cannot achieve full (4400) rpms
I have a set of 17 x 16 for trade / sale
Thank you