I have a 1990 7.4 motor in my dancer and I'm in need of replacing my exhaust flappers. Can anyone point me in the right direction, all the ones I find have an equal amount on each side of thst little rid that separates each side?
Mine has one side longer than the other.
I hope I finally tracked down the noise that's been coming from the starboard side of my motor, towards the rear and near the bottom. Can anyone tell me where I can get a set of these flappers, theyre not exactly centered.
I recently purchased a 1990 250 sundancer and Ive noticed that if you leave the ignition switch on without turning over the motor that there is a warning buzzer that goes off until the ignition switch is turned off or the motor is started. I guess my question is is this just a friendly reminder...
I will be installing a new converter on my dancer due to the fact that the previous owner must have taken the old one out and not replaced it. My question is what gauge wire should I use for it, 14 gauge?
Thanks
Gary
Ok guys, I'm in need of some assistance here. I'm trying to track down to see where my fuse panel is in my 1990 250 dancer, NOT the breaker panel. I'm assuming that there should be a fuse panel located somewhere due to the fact that when I purchased the boat a few months back there were some...
Ok guys, I have a 1990 250 dancer I recently purchased. I am in the need to install a battery charger (Converter) due to one of the previous owners removed it from the boat. Does anyone out there have a 250 dancer that could give me some insight into what the specs they have on their charger...
I recently purchased a new to us 1990 250 sundancer that for some strange reason I cant seem to play the stereo while plugged into shorepower and the batteries turned off. Is there a way I could wire up the stereo so that it can be used while plugged into shorepower and the batteries are turned...
Ok guys, I recently purchased a new to me 1990 250 dancer that has had some hard time starting. The motor is the 7.4 with Bravo drive on her that has roughly 920 hours on her. Ive been thinking about installing a new carburetor on her, does anyone have any suggestions that would work well with...
Ok, so we were out on our boat this weekend. After we came back into our home port we needed to do our pumpout. This is the first time I had to take the cap off so I wasn't sure if it had the chain attached...Well it didn't and overboard it went. Does anyone know where I can get a...
I have a 1990 250 dancer that has some issues with charging. My breaker panel has a switch that says converter, however, when I turn on the switch and leave for the week, the batteries don't charge. Is there anyone out there that knows where this converter would be located at?
Ok guys I just got back from taking her out yesterday for the walleye fishing tournament. Had the motor running for quite some time with the battery switch on both batteries. Got back to the dock and switched it to battery 1 and was real week turning over. Took both batteries out and took...
Ok guys, I'm going to start a new post on this one. I started a thread a few weeks back regarding this issue, but I do have some updates on it. Before the last time I left the boat, I put the converter switch on and turned the battery switch to battery 1 to "try" it out to see if it would...
I have a converter and a inverter switch on my panel. Can someone explain to me what the difference is between the two, which one should I switch on to charge the batteries?
I have a 1990 250 dancer that needs some attention with the sea water pump. I know the pump itself works because i hooked up a jumper cable directly from the pump to the battery and it came on. Does anyone know where there might be a fusible link at or something along them lines? Ive looked...
Im in need of a chartplotter/GPS for my 250 dancer guys. Can anyone give me some advice on if I can get one that has a transducer where I dont have to drill any holes in the transom?
Ok guys, we just got back from taking her for a few this past weekend. One question I have is before we left the marina, we hooked up to shore power, turned on the main breaker panel along with the converter & inverter switches and made sure I switched the battery switch to battery 1. Was I OK...
Ok guys, we recently purchased a new to us 1990 250 sundancer and one question I have is when im hooked up to shorepower for any length of time, will it hurt anything if after I hook up to turn the breaker panel on and switch the converter switch to the on position? I was told that in order to...