Search results

OK, can someone point me to a comprehensive guide to winterizing a boat like mine? Thanks, Tom

Took ownership of a 1991 Sundancer 350 last month and now I’m gathering information about winterizing. Lots of great information on this site. Let me summarize what I know so far for folks to comment on: 1. Engines Fill gas tanks, add stabilizer Run until warm, close fuel supply and fog...

Bypassed switch. Still no joy

Anyone know where the horn relay is located on a 1991 350? Thanks

Update: Today I switched breakers with one in the panel that I know is good and it still tripped. Took a look at the charger (Promariner Protech 4) and it was quite hot and the 2 little fans were not working. Soon after that the breaker tripped again. Looks like I need a new charger. Anyone...

I wiggled the pulleys but did not pull the belt so I'm not sure I got an accurate assessment. Visual inspection while the generator was running was unremarkable. Can any Mercury dealer help me? Could not really tell where the noise was coming from but it sounded like the aft end of the unit...

and where would I find the horn relay???

Thanks. How do I determine if its the converter or the breaker?

On my 1991 Sundancer 350 there is a switch/breaker on the main panel marked AC Converter. My understanding is that this converts AC into DC to keep the batteries charged. Correct? Two questions: 1. Should I turn this switch on only when connected to shore power? 2. What does it mean when...

The horns on my 350 Sundancer stopped working. I got new ones and they don't work either. I checked the voltage at the wires for the horns and I get 12 volts when the switch is depressed. I took the new horns home and hooked them up to a 12 volt power supply and they work fine. What's going...

Hello all, Looking for a generator (1991 Quicksilver 7.5kw) mechanic in the south east Pennsylvania area. Thanks, Tom

Hello all, First post. Have a new to me 1991 Sundancer 350. Had it out this weekend and the generator started making noise after running for about an hour - sounds like maybe a pulley bearing. Shut it down, checked all fluids - all good. Started-up again very easily, but still making noise...