The only TV I tacked is in the master stateroom and I'm not happy with the way that came out. I ordered a small mount and extended the TV so it sits outside the wall (32 inches doesn't fit in the opening). My wife complains that it is too big to watch from bed since it is right there next to...
Block is our favorite destination. Highly recommend more than a day. Travel to and from should be easy for you but just look out for fog and then it's normally very breezy in the afternoon.
I have had a Traxxas Villain for years that I've only run in salt water off the back of my boat. Just washed it off afterwards with fresh water and an occasional spray with WD40. Have had no problems. It's time to upgrade to a self righting boat!
Keith, Wow, great write up. Thank you
I have been trying to decide how to handle my music for the boat so this gives me a great start. Did you upgrade the remotes too? Were they wired???
So if you kept your original Bose, how are you handling the sound from the TV? I am toying with getting...
I have a suspicion the hose was never connected to anything from day 1. I don't see anything it should connect to in the bilge so I'm wondering if other 47 owners have the same issue.
Question for other 47 owners. Have you taken a close look at your shower sump? Look at the most aft connection, mine is labeled AC Condensate. Where does this line go?
In my continuing saga of chasing water in my forward bilge, I have been seeing a great deal of dirty water in the section...
There are no other issues with the boat. The boat has EZ2CY and no it does not seem to be pulling up on the frame in anyway. Hard to say how much pressure is there underway.
The plexiglass does not seem to be glued or held in place in any way to the top frame. If there was pressure or the...
On the front rounded sections of my windshield, the plexiglass is separating from the frame. Has this happened to anyone and any suggestions how to fix this?
Thanks
Mike
Yes, after cruise or a long run at no wake speed, starboard motor stays much colder than port motor. I didn't want to make any assumptions here and was kicking myself for not noting what the temps are at idle. Thanks
Mike
Can anyone with QSC 600s tell me what your water temps are at slow speeds? I am seeing a big difference between my two motors at or slightly above idle after my motors are warmed up. My port engine runs at 156 degrees while my starboard is at 117 degrees. My boat is new to me and I will...