Search results

Nice looking tender Darren, I ended up with an AB Mares VSX 10' 6". I'll put some pictures when I get it up on the boat, thanks for all the great feedback everyone!!!

Out of the water, my launch date is May 4th and I can’t wait

Hey guys, I just wanted to share that I just finished doing the rudder packing. It wasn't too bad; I thought it would be a lot harder. On the port side, I disconnected the hose to the vacuflush and unscrewed it to move it off to the sides. On the starboard side, I removed the sensor over the...

Cool, thanks for the feedback I will get the next one down from 12 feet that is 10'8"Probably the same size as Shaps, I going with the Walker Bay 325..

Does anybody have a 12’ dinghy on the platform?, any input is greatly appreciated, is it too big? Does it block the transom door is it an issue on high seas, does it look too big for the boat etc…I’m looking to buy one and I really like size of it. I previously had a 9’6”and that was fine...

These were my results when I purchased mine, the oil difference is normal!, good luck with your purchase!

Does anybody have rusty SS washers on the inside end of the strut bolts? Is this a common issue on our models? Have you updated to brass bolts washers and nuts? By the way, accessing them is very complicated...

My Cummins mechanic recommends not putting anything on them to avoid isolating them.

One does the job I took these photos at night

I completed my 1,000-hour service, and let me tell you, it was a bit of a financial rollercoaster. The housing for both after-coolers were corroded, and since they don't offer just the housing separately, I had to spend on the complete set at $4,400 each. Adding to the drama, a brand-new turbo...

I have not seen a latch on mine either however our couch is a little different as they changed it on the 2012 model, I know this because I almost bought a '12 when I was on the market a few years back...

"We usually have four people on the boat, and there is ample space to be comfortable for an unlimited amount of time. I've even accommodated six people and a baby, setting up the saloon as a sleeping quarter, which can make it a bit tight, but the fun and memories outweigh the snugness – LOL. I...

"A Holset turbo sold by Cummins costs $6,900, while a Holset not sold from Cummins is priced at $3,000. I'm trying to figure out the difference between the two. If anyone has bought the $3,000 one, could you share your experience and let me know if there are any notable differences?" o_O...

Lol :))

"Wow, that is a great price for the cooler today; they typically retail for over 6k. Do you think your mechanic might have more at that price or perhaps a resale number I can use? I'm willing to drive down to NY tomorrow! :)))) Unfortunately, I also need a turbo for my port engine, and I'm just...

Thanks for the reply, I like the sleeve idea!!!

I'm currently undergoing the 1,000-hour service, and it appears that I might have to replace two after-coolers due to corrosion and pitting on the ends. I welcome any feedback and would appreciate information on pricing from those who have already replaced these parts.

They advertise it as an 08 when she is actually an 05-06... Good money but not for me! :)

looks great x21Aviator!!! Good selection of drinks in special the Bumbu Rum!

Hey group, I didn’t want to add new holes to get more light for the back seat so I found this Lumitec dual color flood light that fits perfectly to the holes already made on the plastic access cover and hardtop, i just had to do do one small hole in the middle of the plastic cover for the wires...