Search results

Good to see you again this WE Cliff. We are out of town this WE, but after that we should be around. Sounds like a good time for sure!

Been busy Cliff, no time for the boat. Looking forward to a good boating season tho. New boat looks nice! I will stop by and see you. I'm on C dock... Text me when you are at the lake. Jason

Cliff, You have a boat with a kitchen now.... buy a grill and leave the anchor set....

Cliff, It will vary according to what you have on, ambient temp, etc. Run the genny when you need to, its really that simple. It won't burn 1 gallon/hr at full load. Where you docking this year? Boat rack? J

Scrubbing bubbles mega foam works great. And it's made for fiberglass

Was out of town moving the oldest into college last weekend. Friends coming in this weekend for some lake R&R. We will be out. Text or call 7O4-six89-8six88. You too Cliff>>>>

Who made the new one for you? That looks great!

Spray a little fuel or starting fluid in the carb on the genny. If starts and dies you know its only a fuel issue. My guess is you dont' have enough fuel in the tank.

Also what dwna1a said, with no lights at all sounds like you have at least 1 battery flat.

Look and see if you have two pickup tubes for fuel in that tank. My genny pumps out of the starboard tank only from its own pickup tube. If it gets below a 1/4 tank, the genny is out of fuel, because the genny pickup is higher in the tank to keep you from running it dry I guess. I can switch the...

I pad will work, but would like to have the chart plotter work. Any help? Need hotmaps east CF/Prem E5 V01.21 or earlier. I dont need your card, just send me the files on it. Thanks J

As fwebster said above, not near enough water. You can tell by the sound the muffler is dry. Hope you didn't cook the new one. You need to verify nothing is blocked from the old impellor coming apart. Good luck!!

Maybe sunday will dry out. Let's hope for the best!

We will be out Saturday Cliff. Text me if you are out and I will let you know where we are headed.

Genny running, blower on... YMMV

Roll up a piece of coarse scotchbrite and insert it in the hose end near arrestor. Oil coming up in the vapor will "condense" on the scotchbrite and run back down the inside of the breather hose. I did this in a old tired small block due to blowby. I got tired of it running down onto the...

Might want to double check, my marine aire is R-22

It's not gonna make the season. At this point you are already on borrowed time. I would fix it asap.

Both mine were found to be leaking when I went through my top ends this winter. Replaced both with these MSD's: http://www.jegs.com/i/MSD/121/8202/10002/-1?CAWELAID=1710767487&CAGPSPN=pla&catargetid=230006180000514795&cadevice=c&gclid=CLm5_MDOvb4CFScV7Aod-XcACg Work great, half the money of...

Might be trouble, you should have left the hood on the motor. Might need to dry out the starter, then you should be gtg!