Search results

Thanks for the reply Scorpio. I am concerned that the circuit breaker panel switches are corroded. Not sure that they would "pop" if I had an issue. I was going to try the remove and identify method for the fuse panel this past weekend but decided to sit in the sun with my beer instead. I'll...

Need some assistance identifying some electrical fuse panels. The first photo is of the fuse panel just below the dashboard. Anyone know what electrical components they support? The second photo is inside the engine compartment on the forward wall of the compartment. Should I replace these...

Thanks. And I saw the PM as well. Appreciate the info. Sent from my iPhone using Tapatalk

What size of Bow Pull Pit did you order from Plasteak?

1988 Sundancer 300 Bench Seat Repairs So I had someone of rather large grits seat on my bench seat in the back of the boat last summer and one of the legs broke. Looking for substitute legs for the seat. Any ideas on replacements? Sent from my iPad using Tapatalk

Yes. Double outlet. It has two USB built into one outlet and the other is a "cigarette outlet" style. Not sure about the fuse size. I will check next time I'm at the boat. BTW both the built in USB and the iPhone charger that I plug into the outlet are blowing out. I tried two different...

Good morning Classic Owners. I am having what I think is probably a "how dumb can you be problem." I want to install a couple of charging outlets near the helm. I purchased the West Marine brand double outlet and wired it to the fuse panel under dashboard. I double checked everything to make...

So I finally had time to get to work on this and is the usually the case with me, the easiest solution was the answer. For the head, it turned out to be the screen in the faucet nozzle that was the issue. All kinds of debris in it. As as for the galley, this was just a little bit of a...

Looking for some help with the water system on my 1988 Sundancer 300. The cold water flows nicely at the galley sink but not the hot water. Neither cold nor hot flows more than a trickle in the head. Any thoughts?

I have an '88 300 Dancer. I want to replace the weather striping/rubber molding around the windshield. Does any one know of a source/part number. Think it is Taylormade but not sure.

Thank you. Next question. I saw photos showing that someone had replaced the carpet in the cabinet with faux wood fooling. Again I read about 50 pages of posts looking for them. Can't seem to locate. Can someone point me to those posts?

Good morning everyone. I have a 1988 Sundancer 300. Looking to replace the rubber molding that goes along the inside and outside of the windshield. I tried to find info in other posts but do not see it. Does anyone have a source for the molding?

I need to replace the center hatch on the top front of my 1988 300 Sundancer. Does anyone have a recommendation on a particular hatch? Any assistance is appreciated. Thanks.

Re: Looking for the rubber/plastic spacer on the swim ladder 1988 300 SD I use TaylorMade Window Savers. I think my ladder metal is 1" in diameter. The window saver blocks snap onto the rails and stay on for the most part.

Hello...I was looking for more information and the photos from your hatch rebed project. Looks like the link to the photos is not working. Can you please send to me? Also, did you replace your front large hatch? My has a broken hinge. Thanks in advance.