I have a 2003 WE with a 5.0 mercruiser and tac was only reading 3700 RPM full throttle, had a tune up plugs /cap/rotor misc stuff and tac now only reads 4000 rpm, should be 4400/4800. Please reply with thoughts. Thanks
Moving my boat to salt water and I have a 2015 Bravo III outdrive, should I use aluminum or zinc for my anodes. I figure my outdrive is already aluminum so go with the zinc.. Your thoughts. Thanks
This summer I am moving my SR 245 WE from the CT River, fresh water to Niantic River, salt water (LI Sound). My engine is raw water cooled so looking for ways to flush out the engine at my dock. Is it as simple as tilting the outdrive up, attaching a pair of flush muffs onto my outdrive then...
I am looking into purchasing a used 2000/2003 Sea Ray 310 and looking for tips for what to look for in my initial visit at the marina. Boats are out of the water at the moment. I now own a WE 245 so I can am somewhat knowledgeable of Sea Rays but the 310 is a inboard, which I like so any review...
Once it stops raining later today I will run her like you mentioned. When I looked in the engine compartment the drain ports looked very dry as if nothing was draining from the bilge. I will let all know, thanks
Hi all,
I have a 2003 Sea Ray 245 WE w/Merc Cruiser and looked in the engine compartment yesterday and i saw a good amount of yellowish slimy water swishing around, temp gage fine, oil pressure fine, got down there while engine was running and i don't see any leaks, any help greatly appreciated...
After two years of looking for the source of water getting into the cabin and getting the carpet all wet in front of the galley was not from rub rails, windows, ect....it was from a screw from installation when my Weekender 245 was built in 2003 had penetrated the hull and after we soda blasted...