Search results

Ok that time of year.. I did not got for it last year, but would like to this year but can not find photos of how it would look on the new hard tops, anyone? John

I really still wonder if they had to wetsand it out. I was told this is the only way then you have to compound the finish. But we will see. Thanks Don

Don good to hear, I was wondering if the SeaRay compound was going to take it out. So how did he remove it? John

Hello Bob I sent you a PM. John

That is to bad.... John

Who went to the Boat Races today?... Anyone hear how the guys are which crashed? John

Hey Liz and Tom I'm also down by the delivery Center. John

Understand the feeling I went down to my boat and found out someone stayed on the boat all night and had a little party. The next day I put a silent alarm which just calls my cell phone:smt038 Can't wait for someone to try it again:smt021 John

Good Luck Don Hope it turns out ok. I wonder if compound works without wet sanding it.. We will see. John

Sorry Robski.... I'm here...

Live in Lindenhurst and so is the boat :) John

Hello Jbuerkett I sent you a mail, my 42 is for sale, it will do 30 but this is 90% of the high end of the motor. I run all day at 21 knotts and burn 12 gallons a hour ( each motor) John

Don that may work but it sounds has this will clear up water staining. What we speak about it a chemical reaction. Don't know if this would work. Would be nice if it does. John

Both had to go direct they were told by the dealer not a SeaRay problem. The them direct... John

Frank you are 100% correct this is what I know after owning 7 of these, however, I was not able to get mine out with compound. John

You can do the following if you have an RS 232 data port which you can connect to a laptop and run a program call Hyper Terminal. Connect this before you start up. Then start up the unit you will see all the information as it goes through start up. Once it looses the signal it will give you the...

Half Off I tried that on a few of mine it works some times depends on how deep it is. Had it every come back? I'm told it comes from a chemical reaction from the mold releaser. John

Sorry to say but it is a Searay problem.:smt021 I have on my current one and had it on 4 of the 7 Searay's. It is from the mold releaser which was not done correctly or remove. Mine was not as bad as yours but it always shows up where the non-skid meets the smooth surface and on the high peaks...

Ok I will give up the lead to tmhudson2 :smt038 His is a better story! John

Seven for me :) :smt021 John