Search results

does SEBU6250-30 superseed SEBU6250-29? I couldn't find a copy of 29, but 30 from 2020 says to still use SAEO 30 and/or single grade API CF oil for 3116/3126 Marine. SEBU6250-30: https://caterpillar.scene7.com/is/content/Caterpillar/CM20210119-674b3-bd997

Have you replaced your fuel filters recently? If not I would. I had the same issue and my fuel filters we're nasty. Works great now.

Mine run on AC only unfortunately. I got the Marvel fridge and freezer.

ttmott, Any updates since this install, lessons learned or anything? Do you think you could have tapped off the existing Sea Ray analog system monitoring module in the bilge? Added any alarms or connected bilge sensors? My Sea Ray System monitor with the red LEDs stopped working, so thinking...

Has anyone replaced or upgraded the original red LED System Monitor on the dash? I realized mine stopped working. I hit the test switch and nothing happens. Getting 12v and ground is good. When I unplug it and plug it back in it gives a faint chrip, but only life it gives. I was thinking maybe...

Skybolt. Just realized my LED System Monitor stopped working. How has hooking the rest of the system up to the AlbaCombi worked out? Were you able to hook up things like the emergency bilge pump, the other bilge pumps, oil pressure, water temp, transmission alarms and such from the Sea Ray LED...

Thanks for the photos and ideas. The leak was discovered in 2011, so hopefully port is good. Port is 100% full, so I imagine difficult to scope. Stephens13, do you recall what it set you back and the cause?

So I've asked an adjusted price of $10k, so if thats the repair cost then I'd be ok with it, and save it for winter. The previous owner ran a fuel line for the generator to port tank. As for what caused the corrosion we don't know yet, but there is new fresh water plumbing in the bildge, I...

What ever happened with this? I'm in exact same scenario, except its a 1997 400DA, starboard tank has a leak. Bank owned, and boat really clean otherwise with healthy CATs.

Anyone replace the headliner inside? If so how, and any recommendations? Thanks!

Why wouldn't you want to lighten the load to a fuel injected 383 / 6.3L? That's what most sites recommend if replacing with gas. Seems like a better power to weight ratio, and should be better on fuel too...

Freygreer- The previous owner repowered my boat in 2009 with S&S Rebuilt engines. They've treated me well :) I think I even had warranty on them up until recently. But yea, it was just a core exchange for the same engine model/type, so no real performance upgrades...

I know not worth the $$ to convert, but wouldn't it have been nice if our 340s came with the Yanmar 6LP diesels!!! Check out these performance improvements in a 1986 390DA: 1986 39 Searay 454 gas to Yanmar 6LP diesel 40 gph at 18 knot cruise to 18 gph at 26 knot cruising speed!!! I saw a pair...

Sounds like its a Chrysler/Mitsubishi CM655NA marine diesel engine

Anyone know where the zinc rod is on a 6.5 Quicksilver Generac? Its supposed to have one, but I cant find it anywhere where its supposed to be. Its supposed to be in the exhaust somewhere?

Has anyone replaced their wood panels around the cockpit and stern with plastic boards like these http://www.eplastics.com/Plastic/Marine_Board-SEABOARD? I have some rot between my transom door and wash-down water outlet, and thinking of using a plastic board to replace the wood and vinyl. I'm...

Looks pretty nice in the photos! http://swimplatforms.com/Sea_Ray_340_Sundancer_&_Express_Cruiser.htm

That's really cool!! Well done Captain!

anyone know what our Sundancers burn hourly at 3100-3200 rpms? thanks! Sent from my DROID RAZR using Forum Fiend v1.0.1.