Search results

Edit seastar

Thanks I was hoping you would see my post. Should I just replace the whole unit or try to repair ? Also it’s a SeaCast ? Do you know the manufacture model number ?

I have a 2000 340 with a leaking hydraulic helm steering pump , how do I remove it ? Are the serviceable ? The leak appears to be from the post that the steering wheel connects to Cheers Jim

Thanks I’ll try that time to go for a drive

Fresh water hoses run up that area and one of the fittings came lose letting water into that space. So Iam also just pumping it into bilge

Thanks I would agree Kinda dumb design with the strainer being there

How does the port side bilge compartment drain into center area where bilge pump is? The stringer between hasn’t any drain holes I can find and a small amount of water is trapped between the stringer besides the hotwater tank and the first engine mount . Cheers

The 1 1/2 fits they changed to 2 inch in 2006

Vacuflush uses 1 1/2 inch pre 2006 2 inch after

1.5" before 2006 2" after

I did my c80 last fall. You will need a blank card, card reader/writer, new navionics gold card. first get update from raymarine website and write it to blank card,then go to c80 power off and insert update card turn , follow on screen instructions. Then remove and put in new gold card done .

If you google merc service bulletin 2001-13 there is some helpful info there

There is, and I couldn't find it either. Just pull the tv out as far as possible and there are four phillips ss screws in the corners under the wood base. The tv and rotating tray can then be removed

I had the 4.3 l with alpha on my previous boat and did not have two places it exhausted. Although exhaust configuration is designed by the boat builder not engine builder so anything is possible. The 13 inch riser clearance isn't applicable here I don't think but flapper sticking is. Google...

Iam a little confused before I suggest some help. An alpha drive draws raw water through the leg and then cools the motor and then exits back through the leg with the exhaust gas. Your boat design differs ?

Another reason to have a dog on board :grin:

With faux teak

Our season doesn't start for a couple of weeks up here but I wiil ask as soon as I see one of the owners around the marina and post back asap. The first boats go in this weekend hopefully.

Side shift is based in my home city of ottawa, Ontario. Several boats at our Marina use both the stern and bow versions and love them. A great lower cost alternative to traditional thruster I believe . Seen one installed looks straight forward to me . Dock mate has a 34 main ship with stern...

Looking to buy a memory foam topper for the aft bed at Costco. Anyone do this or know what size to buy, or the dimensions of the bed ? thx