Search results

Well I got all my other chores done today and my truck and trailer are waiting over at the ramp parking lot for the morning haul out. I'll know for sure shortly after it goes back in if itis prop only or shaft too, I dove down Friday eve. And scoped it out and I really think the shaft was...

Thanks, your reply while a little depressing was fact instead of rumor and that was what I was hoping for.

Found the prop info but need the shaft specs to order a spare. I am pretty sure that the props are 1 1/4" shaft with a 17 x 16 3 blade cupped.

Well if it makes you feel and less " Alone In The World " I managed to do a center hit a 30 foot long semi submerged tree this evening on my way in from a short 3-4 mile ride up river running on top at 2900 rpm, at a minimum I've wasted the port propeller and as I stated earlier " With my luck...

I boat out of Craigs Creek down by the Markland dam, I am hearing that Manhatton Harbor is done, can someone confirm what is going on there, it was my personal favorite in the cincy area to visit.

here is the write up I found after re-searching it. http://www.smokstak.com/forum/showthread.php?t=50493

I had a surveyer tell me that he has began to find railings loose and drawed in from what he thinks is repeated yearly shrink wraping. What do you think ???

I would like to do this as well, I have an mcck in my Marinette and I seem to always fight the points. I have found some information on a site called Smok Stak, kind of a survivalist type site, might want to look for information there.

SpikeDaddy99 Do you boat out of NestEgg Marine ?? I saw you were from Marinette Wi. I bought a 39 Marinette aluminum cruiser from there about 3 years ago. Just curious.............

I just bought a 94 370 DA over the weekend and am quite happy to find this site and the official 370 thread. What kind of average fuel burn are you getting with the 454's. Thanks and glad to be here.............

The original issue was likely just the ball seal in the toilet and was a 20 min. fix. I done both toilets in my Bertram this weekend in 30 min. Get the seals, reattach the wires so it can work properly, makes for funner boating..............

Sounds impossible but I have had a good friend prove me wrong twice on this but .............he has picked up some sticky mud 2 different times and it attaches to the back side of the prop " in theory " and is quite adept and not wearing or slinging off with running but when he backed down real...

Has it been adjusted since the repacking ?? if not, it simply was not done a 100% correct and it should have had a good bit of adjustment range. " BUT " if it keeps getting tightened and the leak comes back, there is two reasons I know of, #1) gland worn, and #2) too small of packing material...

Have there been anyone sucessfully source the needed parts and repair these ?? I have not got into it yet but helping a good friend with his boat and he would like to regain these functions. Doug...

Don't forget to try the simple reset procedure on the SMX face that is printed in the manual, it will tell you in trouble shooting, early on the do a " factory Memory Reset" as follows. Simultanously press "OFF/SET/FAN and them immeadiatly press SET again. I have not personally seen this fix an...

I just bought my 370 with front and rear AC systems and have been doing some reading in order to fix one of the units. I have had many boats and even done some new AC installs and what you are describing sounds 100% normal to me other than you should not be popping a breaker. I can tell you that...