Search results

  1. S

    Launch Date

    My splash date is April 1st, has been for the last 7 years. I can't wait.
  2. S

    Time to sell the boat

    Derek: Why don't you trailer the boat north to DC? There is a lot of good boating in DC/VA/MD. Good luck and Happy New Year.
  3. S

    Marine Painter

    Try Art at Anchor Bay Marina in Dundalk, MD. They are the best.
  4. S

    Buffing and polishing

    I used it last year, found it easy to use and had great results. I will use it again this year.
  5. S

    Annapolis/Baltimore Metro Restaurants

    I would not reccommend Velleggia's, Chiapparelli's and Sabatino's they are over-rated tourist traps. I have stopped going to the aforementioned restauarnts about ten years ago.
  6. S

    Oyster dive

    I belong to York Divers and they go to Kent Narrows every October. You may want to contact them to see specifically where they dive.
  7. S

    Looking for a nice quiet cove

    Try Goodhands Creek off of Kent Narrows.
  8. S

    Official 320 Dancer Thread

    Wow, I checked the on-line price, I think will stay with my 800 thread count sheets and make them fit for a lot less.
  9. S

    Official 320 Dancer Thread

    When my IAC went bad last year it would beep when I throttled it up, at idle it was fine, no alarms. My symptoms were different than what Bob has described.
  10. S

    DA320 Cabin light must be on for Head Light to work.

    This sound's like this is a QC/or design issue wth Sea Ray. I know my Head light is wired liked Bill's. It has been a major PITA.
  11. S

    Official 320 Dancer Thread

    Sorry to hear about your difficulty with this issue. Please let us know what the problem is. Thanks,
  12. S

    DA320 Cabin light must be on for Head Light to work.

    Hey Bill thanks for the tip I am going to try your suggestion. Hopefull my 2003 is wired the same.
  13. S

    Hello from new member

    Welcome aboard from Baltimore, MD
  14. S

    Zincs

    You should also try www.usazincs.com
  15. S

    Zincs

    I was in a similar situation this year, I removed my old zinc's which had some had markings on them or the UPC sticker. If not, you can measure the width of the trim tab zincs which are probably the R-3 type, also measure the bolt spacing on the transom zinc should be either 5" or 5-1/2"...
  16. S

    Hello From Maryland

    Welcome to forum, I also have a 320 Sundancer (2003). We are on the Senecca.
  17. S

    '89 390 EC Polishing Before & After

    I am curious to know what products and application method you will be using.
  18. S

    Old Bay Marina, Upper Chesapeake Bay

    Walz: I can't believe you are considering leaving the Goose? You just can't beat the location and people at the Goose. There are other service options within close proximity. I hope you decide to stay.
  19. S

    Yacht Brite Products

    I am curious to see if anyone uses Yacht Brite products; Buff Magic and Pro-Polish. I look forward to hearing your experience with their ease of use and performance. Thanks,
  20. S

    Dinghy Motor for sale

    Total Eclipse please send me information on the Hurley that you want to sell. Thanks,
Back
Top