Search results

Costcp has them for about a buck fifty!

blue or black smoke?

In the house representin!

seirra and napa are the same part numbers because they are the same parts. I go to napa first, then marine stores.

I think the impellor/waterpump kits have both Gen I and Gen II parts. I have seen this with quicksilver and seirra parts. Something to look at anyway.

Hello, you might try here-----> http://forums.wakeboarder.com/viewforum.php?f=3&sid=37067d33d0377d62a2c5da329927cb33 They may not have tried this with your model, but they might have some helpful information on ballast.

check to see if you have AC output. I am not familar with quicksilver generators, but most generators will not stay running if there is no AC output. They typically use AC voltage as run interlock like a key switch on a car. If you have AC output, remove your shutdown wires one at a time to...

seems like these would ruin my expensive ski rope!

For those with the fuel vent spraying fuel everywhere, check out the following link. I have not purchased one, but was going to make one. 25 bones is a little steep for a plastic can with two suction cups on it...

14.25x21 4 blade should be abit over propped for you if your factory prop is 14.25x21 three blade. You need to look at your wide open throttle RPM's to determine where you are at. I can't say if the High 5 Nelli recommends will work or not. If you find a prop shop local, they will often loan...

free post!

Instead of getting a FM Transmitter that you tune to a radio station. they make one that goes inline with the antanae(sp). it will give you much better sound quality. Something like the in the link below, can't speak for that brand. Quality will be 100% better than a transmitter...

2000 chevy suburban, 5.3 ltre. pulling 1989 200 bow rider i get 12mph on the super slab. I don't know what i get around town pullin the boat, but the gas gauge moves pretty quick. not pulling the boat, i get 15 around town and 18 on the super slab.

try this http://www.mercstuff.com/images/shiftcable.jpg

And it rained practically the whole month of June here in washington. Makes it hard to have fun when when the family is cold and wet. Now the the weather is nice, we are on the lake a couple of times a week.

Fuel bleed tool is a tire chuck. You don't need to buy the Kohler tool. It is a tire air chuck, with a hose nipple instead of an air hose fiitting. Attach a piece of hose to the hose nipple to catch the fuel. Of course you could just push the schrader vavle with a screw driver, but it will...

noise sounds like your u-joints and gimble are dry. have the out drive serviced. as for the water, how fast is it taking on water?

Be careful, if you hit 88MPh you could see some serious s&*t!

thank you, it should be a fun day for all.

Hello, we live in Vancouver Wa and I would like to take the boat to Lake Union and the sound for a day trip. I would like to show the kids the sites. Is this a safe and easy trip in a 200 BR?