Search results

  1. A

    Hand Held Bed up/down Control for 330 Sundancer

    Same Problem here, for my friend's 2008 330DA . The bed goes up, wont go down. It's not the motor. Can't find alot for it online. I could probably rewire it all with a permanent switch in the closet wall, and a 12volt to 24 volt converter, or a 120 volt to 24 watt inverter and a couple of relays...
  2. A

    New canvas from RNR Marine.com ? 1999 270 Sundancer

    Just a heads up for anyone looking to purchase from RNR - I found a similar thread on The Hull Truth, and I was educated real fast about this company. Pay close attention to the attitude of the person that responds for the company and all of the complaints from boat owners. It really speaks...
  3. A

    Borg Warner Specs,oil,ratio?

    Could someone direct me where to find specs for my Velvet Drive? I am looking to change the trans fluid and I have no info on this stuff. I found the motor specs, but not the trans. Thanks Guys!! Chris
  4. A

    Dripless Shafts-How 2 Identify Manufacturer?

    Very helpful, thanks. Yes, these dripless's were replaced a short while ago by the previous owner. Chris
  5. A

    88 300 Weekender Water Inside Cabin

    88 SR 30 weekender I was wondering what everyone found to be the main water leaks into the cabin area on these boats. I have a nasty one that is leaving water in the bottom of closet in my stateroom. It looks as though it eventually travels under the galley if heavy enough. I also noticed the...
  6. A

    name and homeport graphic$

    Everyone is failing to mention one important factor, How many years is the vinyl rated for? You can have a 3 year rated, and that is real garbage, or you can have a 9 year or 11 year, which won't usually last as long as the are rated for, but is still worth getting. The cost of good material...
  7. A

    Dripless Shafts-How 2 Identify Manufacturer?

    I recently bought a 88 30WE and I need to redo the seals on the shafts as well as a cutlass bearing. I did not dive in just yet and I am preparing as much as possible. Are all seals for dripless shafts the same or do I need to know who made the Dripless? Also. where do I find the Serial Numbers...
Back
Top