I'm wondering, if I can pull the switch out of the back, and put the star washers back on it, and then hopefully feed it in without losing them and threading the facing side onto it. We'll see.
My 2007 210 SEL Anchor lights switch came off, and I am having a bear of a time getting it back attached. It consists of a clear pole that extends out to the front from the back of the dash with 2 or 3 star washers and then on the facing side, a switch metal cover with a clear end for the light...
Ah ok, thanks. I'll grab some adhesive caulk at the local hw store.
This is a double-din Stereo - and I figured out a way to do bluetooth on it - I believe. Thanks. There is a bluetooth device you can get to plug into the aux port and then connect to that bluetooth to stream music from any...
I need a glue that's waterproof that can deal with the vibrations too and hold the plastic silver ring on the plastic body of the remote there? Not sure what would work best there. Any recommendations? That ring on mine popped off.
Thanks,
VtSeaRay
Thanks. I'll go down later today to see if I can see it. I was focusing on the front of the engine below the oil filter. I'll look further aft now! Appreciate the help!
Does anyone have a physical location for this sensor on a 5L MPI? I hunted all around the oil filter (which sits prominently on the port side top front of the motor, with oil lines from there, down to the bottom ) and didn't see the pressure sensor anywhere around there. Looked for the blue...
So, took the boat out tonight on the lake, as it was like glass and a good time to delve into just the error if I could recreate it. I was able to, as soon as I went to full throttle to go onto plane. At one point, the oil pressure bumped up, but then it came down - the alarm when I pushed for...
There is no water whatsoever in the bilge, so I think the bellows are good. but no idea about wires.
I had other issues this spring, with a wild turkey that found it's way thru a small hole initially in my shrink wrap (possibly from all the snow/ice this winter, but not sure) - it even laid 2...
2007 210 Select bowrider 5L MPI motor Alpha outdrive. So, Saturday I got the boat ready for summer, ran the muffs on it for a minute or so in the driveway - and ran good, so took it to the lake, drove a 1 mile loop on the water, brought it up to 4500 rpms, for a bit, then back down to 3500 to...
So, I had some alarms go off - Eng Oil Pressure Sensor and pitot sensor (?) failures. More info said to head to port immediately, and see a local dealer (?) Analog gauges looked good, I checked engine oil, that looked good. Strange. I have been fighting what I thought was water in my gas the...
? Mine are starting to get a bit worn looking after 11 years.
I've looked on the SeaRay site, and googled, but haven't had any luck finding any.
Thanks,
VtSeaRay